Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
The prevailing pressure is measured at the sensor element through the deformation of a diaphragm. By supplying power, this deformation
of the diaphragm is converted into an electrical signal. The output signal from the pressure transmitter is amplified and standardised.
Safety
WARNING!
Before installation, commissioning and operation, ensure that the appropriate pressure transmitter has been selected in terms
of measuring range, design and specific measuring conditions.
Non-observance can result in serious injury and/or damage to the equipment.
WARNING!
•
Open the connections only after the system has been depressurised.
•
Prior to opening the pressure transmitter, disconnect it from the power supply.
•
Always operate the pressure transmitter within the overpressure limit.
•
Observe the working conditions in accordance "Specifications".
Intended Use
The pressure transmitter is used to convert pressure into an electrical signal.
The pressure transmitter has been designed and built solely for the intended use described here and may only be used accordingly.
The technical specifications contained in these operating instructions must be observed. Improper handling or operation of the
pressure transmitter outside of its technical specifications requires the instrument to be taken out of service immediately and
inspected by an authorised service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to the intended use.
Dimensions (mm)
M12x1
~64
ø27
27
G1/4A
DIN3852-E
14*
*7/16-20-2A UNF = 12 mm
1
Publicidad
Tabla de contenido
