Troubleshooting - Kalorik FE 40764 Manual De Instrucciones

Exprimidor de jugos vertical lento
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fax +1 305 430 9692

TROUBLESHOOTING

Malfunction
Possible cause
The device
No power
does not
supplied to the
function.
appliance
The lid is not
fitted correctly.
The device is
defective
Low juice
Wrong fruit type
quantity
Fruits are too old
Too much pulp
residue in the
sieve
Loud noise
Bad assembly
Too much pulp
residue in the
sieve
The appliance
Some foods is
is jamming, or
too bulky and
cannot be
clogged the
disassembled
appliance
Pulp ejection is
Pulp spout is
blocked
clogged.
Sieve is clogged
Copies of the I/B. Please reproduce them without any
changes
except
under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
Check the power outlet.
Make sure the plug is correctly
inserted.
Check that the lid and all the parts
are well assembled and that the
safety switch is activated.
Contact the Kalorik Customer
Service.
Use preferably the juiciest type of
fruits.
Fruits that have been freshly and
recently purchased should
guarantee an optimal juice /
nutrients / vitamin content.
Clean the sieve, using the brush
supplied and make sure the holes are
not clogged.
Check that all components are
installed correctly.
Clean the sieve and remove the
excess pulp.
Press the switch in "R" position for 3 to
5 seconds, repeat 2-3 times if
necessary. Remove the lid and
remove the food parts that clogged
the appliances.
Remove all the parts, clean the
strainer housing under running water,
removing the rubber seal underneath
and replacing it after wards. Use
narrow tip of the brush if needed.
Remove all the parts, clean the sieve
under running water, using the
narrow top of the brush if necessary
to remove any residue; make sure
the gutter and small hole at the
bottom of the sieve are free of
residue and clean.
11
Assembly page 11/40
special
instruction
from
Team
Solution
FE 40764 - 120501

Publicidad

Tabla de contenido
loading

Tabla de contenido