Kalorik FE 40764 Manual De Instrucciones página 9

Fax +1 305 430 9692
Feed in fruit and vegetables, wheat grass, nuts, etc. through the
•
feeder tube of the lid. Insert the pusher to push the food towards
the Auger.
Caution: Never put your fingers in the feeder tube of the cover when
the appliance is operating. You might get injured!
Note: Fruit and vegetables should be prepared before juicing, in
such a way that they can easily be pushed through the feeder tube
of the lid.
Avoid overfilling the appliance. In case of overfilling, the juice
•
gets thicker.
If the appliance should stop or get stuck because of overfilling,
•
switch it off immediately and put the switch in position „R"
(reverse) to attempt to remove the clog. Then the motor is put in
reverse only for as long as the switch is depressed.
Note: The quality of the fruit and vegetables is essential for an
optimal quality of the juice. Ensure that you always purchase fresh
vegetables and fruit. Old fruits and vegetables will produce much
less juice, with less nutrients and vitamin content. Wash the fruit or
vegetables thoroughly before juice extraction, because of pesticides
possibly used when the food is grown.
Always bear in mind that certain types of soft fruit which tend to form
'slush' are not ideally suitable for juice extraction, e.g. soft pears,
bananas, boiled apples. For juice extraction do not insert any fruit still
having a kernel!
The weight of the products to be fed in can amount to about 800 g /
2 lb. per batch, depending on the quality and the juiciness of the
food used to extract the juice.
Note: smaller quantities per batch shall ensure better results during
the juice extraction.
CLEANING
After use, switch off and unplug the appliance and wait until the
•
motor stops, i.e. until the juice extractor has come to standstill.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
9
Assembly page 9/40
special instruction from Team
FE 40764 - 120501