Selecting The Spray Setting - WAGNER W 687 E Manual Del Usuario

W 687 E
1.
Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Interior wall paint (dispersions and latex paint)
2.
If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 % until
the feed rate meets your requirements.
Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
1. Attach the carrying strap to the unit. (Fig. 2)
2. Unscrew the container from the spray gun.
3. Aligning suction tube. (Fig. 3)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 3 A)
When spraying objects overhead, turn suction tube back. (Fig. 3 B)
For easier coating of ceilings and lying objects, we recommend the 60 cm
i
HVLP handle extension. (Order no. 2318 452)
4. Set the container on a sheet of paper, pour in the prepared coating material and screw
the container tightly onto the spray gun.
5. Connect the front part with the rear part of the gun. (Fig. 5)
6. Mount the air hose (Fig. 4, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
7. Sling on the carrying strap with the unit.
8. Press the ON/OFF switch at the device.
Three different spray jet settings can be chosen on the spray gun, depending on
the application and target object.

Selecting the Spray Setting

Fig. 6 A = horizontal flat jet 
Fig. 6 B = vertical flat jet
Fig. 6 C = circular jet
Adjusting the desired Spray Setting (Fig. 7)
With the union nut (1) slightly unscrewed, turn the air cap (2) to the desired spraysetting
position (arrow). Then tighten the union nut.
WARNING!
Thinning recommendation
for horizontal surfaces
for vertical surfaces

for corners, edges and hard-to-reach surfaces

Danger of injury! Never pull the trigger while adjusting
the air cap.
GB
dilute by 10 %
37