Descargar Imprimir esta página

Omni cubed HOLE SAVER AUTO Manual Del Usario página 8

Publicidad

INSTRUCTIONS
.1
.2
.3
Sink Hole Saver™ Auto
Use
Ensure material surface is clean.
To adjust cup position: Loosen lock knob
on the vacuum cup assembly.
Slide into desired position and re-tighten.
(see fig. 1)
If needed, disconnect, unwind and
reconnect vacuum tubing for extra
adjustment space.
To apply with automatic pump: Place
Sink Hole Saver on material.
Turn on Rechargeable Power Pack (RPP)
to activate the vacuum pump. (see fig. 2)
Push down on the rail above each cup to
establish the initial seal.
Once cups are fully suctioned down,
depress thumb pumps to visually monitor
vacuum pressure.
Keep pump powered-on while in use.
To apply manually: Push down on the
rail above each cup to establish the initial
seal, then pump thumb pumps until the
red warning collar is no longer visible.
(see fig. 3)
12
To remove: Turn off the RPP to deactivate
the vacuum pump.
Press both red vacuum release valves to
evacuate the pressure. (see fig. 4)
You can also lift up on the vacuum
release tab on each cup to break the seal
individually. (see fig. 5)
Lift the unit off the material.
Cleaning: Wipe down cups and other
components with a damp cloth and
reapply protective cup covers.
Rechargeable Power Pack (RPP)
See full instructions included with your
RPP.
Charging: Turn on RPP power.
Connect smart charger to the RPP, then
into wall outlet. Must be done in this order.
The smart charger will display a red light
while charging.
Ignore the battery life indicator on the RPP
while charging; when the smart charger's
light turns green, charging is complete.
13
. 4
.5
omnicubed.com

Publicidad

loading