ENGLISH
14
> SETTING AND PROGRAMMING PROCEDURES
> PROGRAMMING SENSOR
IMPORTANT: First program a transmitter with the motor then set the limits of the motor and finally set the
transmitter with the sensor.
Programming procedure of sensor is like adding a new transmitter to the motor so:
1. Press and hold PROG-TX button on the back of transmitter till the motor starts moving, then
releasePROG-TX button (the motor stops).
2. Press and hold for at least 3 seconds S button on the wind sensor until LED 9 on the wind
sensor blinks. Wind sensor is now programmed.
> CHECKING CONNECTION BETWEEN SENSOR AND MOTOR
1. Press and hold W button for at least 3 seconds. If properly linked the motor goes UP.
2. Press and hold S button for at least 3 seconds. If properly linked the motor goes DOWN.
> SETTING WIND THRESHOLD (5 levels to be selected ONLY through the transmitter)
1. Using already set transmitter press simoultaneously UP STOP DOWN buttons till the motor makes a
number of jogs corresponding to the number of wind threshold.
2. In this status press UP to increase the wind threshold or DOWN to reduce the wind threshold. Anytime you
press the motor makes a number of jogs corresponding to the new wind threshold
3. Press STOP to confirm the selected wind threshold. The motor makes the selected number of jogs as
confirmation.
The wind speed level that the sensor detects is displayed by the number (from 1 to 5) of LEDs ON.
WIND - LEVEL OF SENSITIVITY
Level 1
Level 2
Level 3
Level 4 (default)
Level 5
> [QCWSSX]
SETTING SUN THRESHOLD
(4 levels to be selected ONLY on the sensor)
Press shortly and sequentially the S button to change level.
The level is displayed by 4 led on the S side.
- NO LED > Sun disabled
- LED 6 > level 1 (5 Klux - low lightness, early morning)
- LED 7 > level 2 (20 Klux)
- LED 8 > level 3 (40 Klux)
- LED 9 > level 4 (60 Klux - high lightness, noon)
10 Km/h - Low wind speed
20 Km/h - Low/medium wind speed
30 Km/h - Medium wind speed
40 Km/h - Medium/high wind speed
50 Km/h - High wind speed
LED
6
1
7
2
8
3
9
4
5