Connecting to a Gas Cartridge
•
If the gas lantern is fitted to an empty cartridge, then
please read "Removing Cartridge".
•
This gas lantern is fitted with a sealing washer. Check the
sealing washer is present and in good condition before
connecting the cartridge.
•
Do not use if the seal is damaged or worn.
•
Do not use appliances that are leaking, damaged or do
not function properly.
•
Only change gas cartridges outdoors or in well-ventilated
places away from naked flames, any other ignition
source, and other people.
•
Close the control valve by turning the knob clockwise (OFF).
•
Screw out the cartridge cover anticlockwise; attach the gas cartridge and screw in the cartridge cover
clockwise.
•
Place the Cosiscoop on a hardened, non-flammable and clean
surface or on a table that can bear weight. Make sure the
Cosiscoop is stable and level.
•
Hold a long lighted lighter (with a minimum length of 140mm)
near the burner and slowly open the control knob anticlockwise
(ON).
•
If the burner does not light after 5 seconds, turn off gas valve and
wait 1 minute before re-lighting.
•
If the unit does not light after several attempts, contact your
retailer.
•
Avoid moving the gas lantern once it is lit because this could be
dangerous.
•
Always operate the gas lantern at least 1 meter away from walls
and ceilings and never near flammable materials.
CAUTION: accessible parts of this gas lantern may become very hot during and after use. Handle with care.
Keep young children away from this appliance.
•
Extinguish by turning control knob fully clockwise (OFF). Check that the gas lantern is
fully extinguished before leaving unattended.
•
If necessary, the handle can be removed and handle holes on the shell can be cover
by two rubber mounts.
•
The handle must keep down when the appliance is working.
•
Don't carry the handle when operating, it will be very hot!
•
Always store the gas lantern in a well-ventilated area.
Removing the Cartridge
•
Only change gas cartridges if they are empty.
•
Make sure the gas lantern is off by turning the control knob fully anticlockwise (Off) and check that the
gas lantern has been fully extinguished.
•
Only change gas cartridges outdoors or in well-ventilated places away from naked flames and any
other ignition sources.
If there is a smell of gas or you suspect a leak once the cartridge has been
fitted, take the appliance to a well-ventilated outdoor location away from
any ignition sources. If you want to check for leaks in your appliance, do
so outside.
Do not try to detect leaks using a flame; use soapy water.
sealing
190 gr gas
cartouche
Lock gas
cartouche
5