Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting to a Gas Cartridge
•
If the gas lantern is fitted to an empty cartridge, then
please read "Removing Cartridge".
•
Remove the pebble stones before removing the attached
cartridge.
•
This gas lantern is fitted with a sealing washer. Check the
sealing washer is present and in good condition before
connecting the cartridge.
•
Do not use if the seal is damaged or worn.
•
Do not use appliances that are leaking, damaged or do
not function properly.
•
Only change gas cartridges outdoors or in well-ventilated places away from naked flames, any other
ignition source and other people.
•
Close the control valve by turning the knob clockwise (OFF).
•
Screw out the cartridge cover anticlockwise; attach the gas
cartridge and screw in the cartridge cover clockwise.
If there is a smell of gas or you suspect a leak once the cartridge has
been fitted, take the appliance to a well-ventilated outdoor location
away from any ignition sources. If you want to check for leaks in your
appliance, do so outside. Do not try to detect leaks using a flame; use
soapy water.
•
Replace the pebble stones. The stones shall not cover the
burner.
•
Place the Cosiscoop on a hardened, non-flammable and
clean surface or on a table that can bear weight. Make sure
the Cosiscoop is stable and level.
•
Hold a long lighted lighter (with a minimum length of
140mm) near the burner and slowly open the control knob
anticlockwise (ON).
•
If the burner does not light after 5 seconds, turn off gas
valve and wait 10 seconds before re-lighting.
•
If unit does not light after several attempts, contact your
retailer.
•
Avoid moving the gas lantern once lit because this could be
dangerous.
•
Always operate the gas lantern at least 1m away from walls
and ceilings and never near flammable materials.
CAUTION: accessible parts of this gas lantern may become very hot during and after use. Handle with care.
Keep young children away from this appliance.
•
Extinguish by turning control knob fully clockwise (OFF). Check that gas lantern is fully extinguished
before leaving unattended.
•
If necessary, the handle can be removed and handle holes on the shell can be cover by two rubber
mounts
Removing the Cartridge
•
Only change gas cartridges if they are empty.
•
Make sure the gas lantern is off by turning the control knob fully anticlockwise and checking that the
gas lantern has fully extinguished.
•
Only change gas cartridges outdoors or in well-ventilated places away from naked flames and any
other ignition sources.
•
Only store and change gas cartridges well away from flammable objects, any ignition sources (candle,
cigarettes, other flame producing appliances), pets and people.
•
Remove the pebble stones before removing the cartridge.
sealing
190 gr gas
cartouche
Lock gas
cartouche
5
Publicidad
