brennenstuhl MULTI 4000 MA Manual De Instrucciones página 10

Operating instructions
The lower the brightness selected, the longer the floodlight will burn.
If the switch is left in any of its "on" positions for longer than 5 seconds,
then pressing it once again will always turn it off.
If the rechargeable battery is almost flat, the LED floodlight will flash 5 times. Afterwards,
the floodlight remains on for approx. 10 minutes – depending on the battery capacity –
with 50% brightness before it is switched off by the deep discharge protection function.
This ensures sufficient time to change the rechargeable battery or complete work.
CHARGING THE RECHARGEABLE BATTERY
Only use one of the manufacturer's original charging device: Bosch, Dewalt, Makita,
Metabo (CAS), Milwaukee.
TRIPOD MOUNTING
By means of the holes in the holding bracket, the floodlight can be mounted on a
Brennenstuhl tripod.
SCOPE OF DELIVERY
Floodlight, 4 multi adapters Bosch, Makita, Metabo, Milwaukee/Dewalt, bag.
ACCESSORIES
Suitable accessories are available on our homepage www.brennenstuhl.com.
CLEANING
Before cleaning, remove the battery from the floodlight.
Do not use solvents, caustic cleaning agents or similar products.
Only use a dry or slightly moistened cloth for cleaning.
MAINTENANCE
10
013621 BA_MULTI 4000 MA.indd 10 013621 BA_MULTI 4000 MA.indd 10
ATTENTION: The LED lamp does not contain components that
require maintenance. The light source of this lamp cannot be
replaced. If the light source has reached the end of its service life,
the entire lamp has to be replaced. The lamp may not be opened.
MULTI 4000 MA
29.06.21 08:20 29.06.21 08:20