Important - Hergom SERE 100 2C Instrucciones Para Instalación, Uso Y Mantenimiento

3 - ASSEMBLY OF THE FAN

IMPORTANT:

The fan must be assembled prior to installing the
device. Ensure the fan works before starting the
assembly.
1. Remove the cast iron grid and the base from the
device. Take special care with the vermiculite
pieces, as they may break. (Fig. 3)
2. Unscrew the screws of the side covers that
give access to the fans located under the base.
(Fig.4)
3. Identify where the wall bushings are located.
They will be located on one side of the device
and it is here where you need to fit the
thermostat.
4. Tie a not in the line of force and insert in
through the wall bushings leaving the knot on
the outer side.
5. Channel the longest part of the cabling through
the rectangular tube that joins both ventilation
FIG. 3
FIG. 4
areas.
6. Assemble the fans on the supports with the
self-tapping screws provided, as shown in the
diagram below.
Assemble both fans in the same manner.
7. Assemble both fans inside the device with the
M6 screws provided:
8. Assemble the supporting resistance anchor
base with the M4 screw provided, always on
the side where the wall bushings have been
fitted:
FIG. 5
FIG. 6