SNOWJOE SJ624E Manual Del Operador página 3

7. If the snow thrower strikes any object, immediately
stop the snow thrower, then inspect for damage –
Repair any damage before restarting and operating the
snow thrower.
Safety Instructions for Walk-Behind
Snow Throwers
• Read the operator's manual carefully – Learn your snow
thrower's applications and limitations as well as the specific
potential hazards related to this machine. Do not use this
machine for any purpose other than the one for which it
was designed. Otherwise, it may cause mechanical defects,
serious damage or personal injury.
• Preliminary unit inspection – Thoroughly inspect the unit
before use. Make sure all the parts are secure and installed
correctly. If you notice any abnormalities, do not use the
machine until it has been properly repaired. Always
perform a test run the first time you use the snow thrower
or after replacing parts to ensure that the unit is
functioning properly.
• Preliminary area inspection – Clear the area to be plowed
before each use. Remove all objects, such as rocks, broken
glass, nails, wire or string, which can be thrown by or
become entangled in the snow thrower. Keep the area of
operation clear of all spectators, particularly children
and pets.
• Excessive force – The snow thrower was designed to
respond at a certain rate for various snow conditions for
optimum safety and performance. Do not force it; keep
pressure constant.
• Malfunctioning switch – Do not use the snow thrower
if the switch does not turn it on and off. Any electrical
appliance that cannot be controlled by the switch is not
safe to use and must be repaired.
• Hitting an object – If the snow thrower accidentally strikes
an object, follow these steps:
i) Stop the snow thrower and unplug the unit
ii) Inspect for damage
iii) Repair or replace any damaged part before restarting
and operating the snow thrower.
• Discharge chute safety – Never direct the snow discharge
chute at the operator, at bystanders, at vehicles or at
windows. The discharged snow stream and foreign objects
accidentally picked up by the snow thrower can cause
serious damage and personal injury. Do not use your hands
to unclog the discharge chute. Stop the motor before
removing debris.
• Hand-held operating position – Operation of the snow
thrower in the hand-held position is unsafe.
• Abnormal operation – If you notice the snow thrower
running in an unstable state or hear abnormal sounds from
the engine, immediately stop the machine, disconnect the
power and contact an authorized Snow Joe
service center.
• Noise control – When using the snow thrower, you must
respect local laws and regulations regarding noise control
and environmental protection. To avoid noise disturbance,
you should carefully decide upon an appropriate operation
time and consider the surrounding conditions.
• When work is completed – Disconnect the snow
thrower from the power source when not in use, when
changing accessories and before performing any
maintenance function.
• Store safely – Store the snow thrower indoors in a dry area
between uses. Keep it in a locked area, where children and
unauthorized users cannot gain access. Do not store the
machine while it is still connected to the power source as
this may result in damage and injury.
• Maintain for safety and longevity – Check for
misalignment or binding of moving parts, breakage of
parts and any other conditions that may affect the unit's
operation. If damaged, repair or replace the damaged part
before use. Use only original replacement parts designed
specifically for your model. When replacing any parts,
you must strictly observe the instructions and procedures
described in this manual. Special care should be paid to
any rubber parts, since these parts may increase the engine
load and decrease its mechanical power if damaged.
Always check that all bolts, nuts and knobs are tight before
using the snow thrower!
+ Sun Joe
® ®
3