Powering On And Off - SNOWJOE SJ624E Manual Del Operador

Securing the Extension Cord
1. For safe and efficient use of your snow thrower, use only a
UL-, CSA- or ETL- rated extension cord recommended for
outdoor use. Refer to the Extension Cord Chart on
page 2.
2. Form a loop with the extension cord and push the loop
through the slot on the cord restraint hook. Position the
loop over the hook and pull the cable back through the
slot (Fig. 14). Securing the extension cord in this manner
will prevent it from accidentally disconnecting from the
power supply during operation.
Fig. 14
3. Insert the female end of the extension cord into the
appliance's polarized male plug (Fig. 15).
Fig. 15
4. Note that the snow thrower has a polarized male plug –
one prong in the plug is slightly longer and wider than the
other (Fig. 16). The extension cord female end should be
likewise polarized so that the extension cord fits snugly
into the appliance plug.
Fig. 16
m
WARNING
Damaged electrical cords present risk of fire,
electrical shock and serious bodily injury.
Before operating the snow thrower, carefully examine
the electrical cord. If the cord is damaged, do not use
the snow thrower. Replace or repair the damaged
cord immediately. If you need assistance, contact an
authorized Snow Joe
®
Snow Joe + Sun Joe
®
1-866-SNOWJOE.
Powering On and Off
m
WARNING!
The auger starts rotating immediately
after the snow thrower is switched on. Keep hands
and feet away from the auger.
1. To switch the snow thrower ON, press the safety switch
button, then squeeze the switch bar lever (Fig. 17).
Fig. 17
Switch bar
lever
Safety switch
button
2. Once the snow thrower starts, release the safety switch
button and proceed with operation.
3. To power OFF, release the switch bar lever.
9
m
+ Sun Joe dealer or call the
®
customer service center at
®