Package Content - Avtech AVM359A Guía Rápida

QUICK GUIDE
Please read instructions thoroughly before operation and
retain it for future reference. Online manual download:
www.surveillance-download.com/user/m359a.swf
 INSTALLATION (Type 2)
Step1: Paste the installation sticker on where you want to install the camera. Then, drill 4 screw holes as indicated on the
sticker, and fasten two screws to the top as shown in the picture.
Note:
Leave some space between the screws and wall to hook the bracket later.
Step2: Hang the camera at the screws you just fixed, and make sure the camera
stays in place. Decide the cable direction (up / down) before you fasten the
screws tight to the wall.
Step3: Fasten all screws to secure the bracket to the wall.
Step4: Adjust the vertical and horizontal angles of the camera with the supplied
wrenches for a better viewing.
Note:
To adjust the angle, for
example the vertical angle,
DO NOT
loosen / fix one
side of the screw to the end
at once.
Please do adjustment by
taking turns on both sides till
the angle is fixed.
Otherwise, the angle of the
camera might not be fixed.
 PACKAGE CONTENT
Before starting to set up your camera, please make sure
items below in your box:
or or
Quick
Camera
guide
For selected models only:
Wall Installation
Screws Wrenches
Plugs Sticker
*
 INSTALLATION (Type 1)
Step1: Fix the bracket to where you want to install the camera
with the supplied three screws.
Step2: Remove the Joint Lock from the bracket. Then, connect
the Joint Lock to the backside of the camera.
Step3: Connect the camera with the Joint Lock connected to
the bracket. After that, secure the Joint Lock to fix.
Next, fix the shield on the camera by turning the
supplied small screw into either hole on the camera.
Step4: Connect the camera to power.
Bracket Desiccant
 CABLE OVERVIEW
Below is an overview of various cables that can be used with
the camera. Besides, it is followed by a table, which offers
simple descriptions of cable connection.
Cable
Power cable
RJ45 network cable*
GND
Alarm-in
Alarm-out
RESET
* For PoE (IEEE802.3af) installation, make sure your network cable has the
maximum cable resistance of 20Ω, such as CAT.5e or CAT.6 cables, to conform
to the standard of IEEE802.3af.
m359A(H)_459A(H)_459B(H)_565A_561(H)_552A(H)_B(H)_quick_V1.6
536z
RJ45 network cable
Alarm-in
GND
RESET
GND
Alarm-out
Power cable
Description
DC12V power supply.
Connect it to a RJ45 cable.
Ground wire
Reserved for external alarm device connection
Reserved for external alarm device connection
Remove the insulating coating of wire, and
twist it with a ground wire together to reset
default camera