Avtech AVM359A Guía Rápida página 5

 ADJUST FOCAL LENGTH & FOCUS
Note: The appropriate temperature for focus adjustment is
0˚C ~ 40˚C, and prevent adjusting in moisture
environment.
Step1: Loosen the screw on the
sun shield, and slide the
shield to remove it (if the
shield is fastened to the
camera).
Then, rotate the front
cover to reveal the inner of the camera.
Step2: Remove two bags of desiccants placed in the camera.
Note: Remember where these bags were placed. New
desiccants will be placed into the camera later in
Step4.
Step3: Find two handles in the camera to adjust focal
length and focus. Move the handle near to the
main board first to find the best surveillance area,
and move the hand near to the lens to adjust the
sharpness of the image.
Adjust focal length
Adjust image
sharpness (focus)
 CAMERA CONFIGURATION
For advanced configuration of your camera, please be
sure you have connected your camera to NVR as
shown in "HD System Connection".
Note: It's recommended to connect the camera to the same
brand's NVR to get the best performance. To use the
camera individually, please refer to the camera's
operation guide supplied in the CD to know how to
configure this camera solely.
Step4: Open the new bags of desiccants supplied in the
package to replace the old ones within 30 seconds,
or the desiccants might absorb too much moisture in
the air.
Slide Loosen
Tip: To know if the desiccants are ok, find the desiccant
colored in the bag against light. If the color of the
desiccant is yellow, this bag is ok and ready to use. If
the color of the desiccant is dark green or even red,
please replace this bag with a new one.
Step5: Place the front cover back.
Step6: Slide to mount the shield on the camera before
tightening the screw.
Step1: Connect PC to the HUB connected to your camera(s) with RJ45 network cable.
Step2: Search available devices with "IPScan.exe"; to download "IPScan.exe", please visit
www.surveillance-download.com/user/IPscan.zip
Step3: After searching, set your PC in the same network segment as the
specific camera you want to access, such as "192.168.30.xxx" (xxx
could be 0~255) in our example
Step4: Note down the IP address and port number of the camera you want to
access, such as "192.168.30.1" and "88" in our example.
Step5: Open Internet Explorer on the PC, and enter the IP address and port
number in the URL column to access the camera. The format is
http://ipaddress:portnum, such as http://192.168.30.1:88 in our
example.
 Insert Micro SD Card
Only selected models are equipped with a micro SD card
slot for local video recording.
The data originally saved in the micro SD card (if any) will be
removed after inserting it to the camera.
The camera doesn't support hot-swapping. Please insert or
remove the micro SD card with power disconnected.
Please follow the directions in the below graphic to insert Micro
SD card properly:
Note: It's recommended to use a pair of tweezers for
inserting / removing Micro SD card.