Noise And Vibration; Technical Data - Tyrolit DHE32 Manual De Instrucciones

TYROLIT
 Identify the power tool with stickers only.
Do not drill any holes into the housing.
 The mains voltage and the voltage
specifications on the rating plate must
correspond.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A-weighted noise level of the power tool
is typically:
– Sound pressure level:
– Sound power level:
– Uncertainty K:
Total vibration value:
– when hammer drilling:
– Emission value a
– Uncertainty K:
– when chiselling:
– Emission value a
– Uncertainty K:
ATTENTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE!
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary to
take into account the times when the tool is
switched off or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
DHE32
92 dB(A);
103 dB(A);
3 dB.
: 13.34 m/s
h
1.5 m/s
: 10.60 m/s
h
1.5 m/s
keep the hands warm, organisation of work
patterns.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).

Technical data

Hammer drill and chisel
hammer
Rated power
No-load speed
No-load impact rate
2
Max. single impact
2
energy (according to
"EPTA procedure
05/2009")
2
2
Lubrication
Tool holder
Max. drill diameter
– concrete
– masonry
– (HM drill bit)
– wood
– metal
Weight according to
"EPTA procedure
01/2003"
DHE32
W 900
rpm 0–850
rpm 0–3700
J 4.8
Grease
SDS-plus
mm 32
mm 82
mm 32
mm 13
kg 4.6
17