Product Set Up; Installation Concerns; Seat Assembly; Product Use - auna aace Manual De Instrucciones

Product Set Up

Installation Concerns

DO NOT install this booster on vehicle seats with
Lap Belts only. (1)
This booster is suitable for vehicle seats with
a 3-point Retractor Safety Belt. (2) If your
vehicle has ISOFIX Anchor Points, we strongly
recommend that you connect the ISOFIX
connector to the ISOFIX Anchor Points together.
(3)
DO NOT install this booster on vehicle seats that
face sideways or rearward with respect to the
moving direction of the vehicle.
Please refer to your vehicle owner's manual for
recommended or suggested installation positions.
(4)-1
This booster must be installed in the rear vehicle
seat. (4)-2
DO NOT install this on movable vehicle seats
during installation.

Seat Assembly

1
With the seat lying flat, attach the seat back to
the booster seat bottom by hooking the seat back
hooks over the seat bottom as shown. (5)
11
AACE instructions
2
Now rotate the seat back up until it clicks into
position and the seat is fully upright as shown. (6)

Product Use

Side Impact Protection (SIP) Pods
1
To open the SIP Pods pull out on the side tab (7).
2
To close push button (8)-1 and push in (8)-2.
SIP Pods should be deployed whenever the
booster is installed in a vehicle. You may push in
the inboard SIP pod if it interferes with an inboard
passenger.
Height Adjustment for Head Support
1
The Head Support height can be adjusted for
best fit to your child and proper placement of the
Vehicle Shoulder Belt.
2
To adjust, squeeze the Head Support Adjustment
Lever, then pull up (9) or push down (10) the Head
Support until it locks into one of the 11 positions
as shown.
Before adjusting the head support height have
your child lean forward slightly.
As the Head Support is adjusted up, the sides of
the seat automatically move outward to provide
more shoulder room.
12
AACE instructions