Uline SHOP-VAC H-5011 Manual Del Usuario página 3

1. Remove vacuum cleaner and all accessories from
the carton.
IMPORTANT! Open tank cover by pushing
latches or clamps outward with thumbs and
remove any accessories that may have been
shipped in the tank.
TOP HANDLE
If the top handle is not
installed on your unit, align
holes in handle and holes
in motor cover and secure
with screws provided.
(See Figure 2)
METAL TANK WITH
PLASTIC DOLLY AND REAR WHEELS
1. Locate two casters, two large rear wheels, one axle,
one tool rack and two cap nuts.
2. Assemble as follows:
a. Make sure the cord is disconnected from the
receptacle. Then, remove the tank cover.
b. Turn tank upside down so the bottom is facing up.
3. Place axle upright on
a hard surface and
carefully hammer on
one cap nut.
(See Figure 3)
4. Place one wheel on
axle and slide down
to cap nut. Be sure flat
side of wheel hub is
facing outward. If metal
spacers (not needed for
all models) came in the
hardware pack, place
one on axle and slide
down to wheel.
(See Figure 4)
5. Slide axle through holes
provided in tool rack. If
included, slide second
metal spacer (not
needed for all models)
over axle and slide
down to tool rack.
(See Figure 5)
PAGE 3 OF 27
UNPACKING
ASSEMBLY
Figure 2
Figure 3
Figure 4
Figure 5
2. Assemble vacuum following the instructions below.
3. Depending on dry pick-up or wet pick-up operation,
install proper filter. (See page 5 for filter guide)
4. Replace cover and make sure latches or clamps
are secured over raised area of tank cover.
6. Slide remaining wheel
onto axle and carefully
hammer on second
cap nut. (See Figure 6)
7. Install tool rack
assembly onto dolly
(already installed on
tank) by placing large
slot in tool rack over rim
on back of dolly. Push
tool rack onto dolly until
the bottom of tool rack
is flush with bottom of
dolly. (See Figure 7)
NOTE: It is normal
for tool rack to fit
tightly onto dolly.
8. Secure with four screws
provided. (See Figure 8)
9. If plastic flat washers
are included in
hardware pack, place
one flat washer over
stem of each caster.
NOTE: Flat washers
are not required
with all units.
10. Insert casters into front
of dolly by placing
stem of casters into
holes provided. Apply
pressure and twisting
motion until casters
snap into place.
(See Figure 9)
11. Return tank to upright
position.
Figure 6
Figure 7
Figure 8
Figure 9
0521 IH-5011