Uline SHOP-VAC H-5011 Manual Del Usuario página 4

CARRIAGE HANDLE ASSEMBLY
1. Take two handle supports and two 1"
screws. Place screws through the
hole provided in center of each
support. (See Figure 10)
2. Position the tank in the upright position.
Facing the inlet, put the support
assemblies inside the tank. Then,
place the screws through the holes
provided on left side of the tank.
Make sure the plastic portion is
located inside the tank. Turn the
supports until the back of the supports fit flush against
the inside curve of the tank. (See Figure 11)
3. Remove any webbing that attaches
the tank handles to each other.
Take the side tank handle with the
letter L and position it on the outside
of the tank where the support
assemblies are installed. The
U-shaped cutout on the bottom end of the handle
must face the rear of the tank. Secure the side tank
handle to the tank with the screws in the support
assemblies. (See Figure 12)
4. Repeat steps 1 to 3 using right side of tank and the
remaining side tank handle marked with the letter R.
5. Position metal carriage handle
outside of tank and under the tank
handles. Be sure to spread ends of
carriage handle when assembling
to prevent damage to tank. Line up
holes in ends of carriage handle
with holes in bottom of tank handles. Make sure
carriage handle is in the U-shaped cut on the tank
handles (located towards rear of unit). Secure with
1½" screws provided. (See Figure 13)
PAGE 4 OF 27
ASSEMBLY CONTINUED
SIDE TANK HANDLES ASSEMBLY
1. Attach carriage handle to tank by
Figure 10
inserting bolt through the center hole
of handle and tank, secure with nut
provided. Attach side handles with
screws provided. Be sure to spread
ends of carriage handle when
assembling to prevent damage to tank. (See Figure 14)
Figure 11
BASKET ASSEMBLY
1. Insert basket through center of
carriage handle and slide into
place. (See Figure 15)
Figure 12
SIDE TANK HANDLES ASSMEBLY
1. Attach handles to tank with screws
provided. (See Figure 16)
TOOL HOLDER ASSEMBLY
(NOT STANDARD WITH ALL MODELS)
1. Set tank cover onto the tank. Position with back of
tank cover facing you.
Figure 13
2. Take tool holder and
place tabs on tool
holder into slots on
back of tank cover.
(See Figure 17)
3. Press down until tabs snap into place.
Remove tank cover from tank and
refer to the assembly and operation
section. (See Figure 18)
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18
0521 IH-5011