Publicidad
Step 14
Flip the drawer over onto the left DRAWER SIDE (D225).
å
Diagram 1. Insert the tabs on a DRAWER ACTUATOR (S) into
å
the slots in a EXTENSION SLIDE (N). You may need to insert
one tab fi rst, then the other.
Diagram 2. Visually check that the DRAWER ACTUATOR (S) is
å
seated in the EXTENSION SLIDE (N).
Diagram 3. If the DRAWER ACTUATOR is not seated, use your
å
hammer to gently tap the SLIDE until the tabs are properly
seated in the slots.
Now, fasten this EXTENSION SLIDE (S) to the right DRAWER
å
SIDE (D225). Use two GOLD 5/16" FLAT HEAD SCREWS (GG).
Repeat steps 13 and 14 for the other drawer.
å
2
.
S
3
.
www.sauder.com/services
Post
D225
Seated
S
D225
409044
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Slots
N
1
.
These tabs must
S
insert into the slots.
N
D225
GG
Open end
Page 19
Publicidad
