How To Use; Cleaner Descriptions; Polarized Plug; On-Off Switch - Hoover WindTunnel Manual Del Propietário

STEP III Position tools
1-14
Place smaller unridged end of wand
into bottom of rack. Snap wand into
clip. Repeat with other wand.
Open tool cover.

2. How to use

Cleaner description
2-1 1
2
3
5
6
7
19
17
18
16
15
14

Polarized plug

To reduce the risk of electric shock,
this appliance has a polarized plug
(one blade is wider than the other).
This plug will fit in a polarized outlet
only one way. If the plug does not
fit fully in the outlet, reverse the
plug. If it still does not fit, contact a
qualified electrician to install the
proper outlet. Do not change the
plug in any way.
1-15
Insert ends of dusting brush (A),
crevice tool (B) into storage areas.
Secure furniture nozzle (C) in clip.
Close tool cover.
The assembled cleaner will look like the drawing.
3
4
8 20
9
10
11
12
12
13
3

ON-OFF switch

Plug cord into electrical outlet.
To turn cleaner ON, push switch up.
To turn cleaner OFF, push switch
down.
A
C
1. Handle
2. ON/OFF switch
3. Cord hooks: wrap cord
around hooks for storage.
The top hook can be
rotated right or left for
easy cord release.
4. Hose
21
5. Tool cover
6. Dusting brush
7. Furniture nozzle
8. Crevice tool
9. Carrying handle
10. Wands
11. Final filter door
12. Handle release lever:
step on lever to lower
handle to operating or
low positions
13. Edge groomers
14. Furniture guard: helps
prevent cleaner from
13
marking furniture.
1-16
B
Remove switch lock (A) above
ON/OFF switch (B) by pulling it
straight out. Dispose of switch lock.
If switch lock has come off during
assembly, make sure switch is in
OFF position (down) before plug-
ging cord into electrical outlet.
15. Nozzle control knob:
slide knob to correct set-
ting for height of carpet
being cleaned
16. Headlight
17. Check bag indicator
18. Stair cleaning handle:
19. Bag door
20. Cord clip
21. Hose rack
Operate cleaner only at volt-
age specified on data plate
on bottom of cleaner.
This cleaner is intended for
household use.
2-2
Cord clip
To help keep the cord out of the way
while vacuuming, position cord in
cord clip (A) located at rear of
cleaner on hose rack.
A
B
located below lower edge
of door.
A
5