Lcd Display Screen; Getting Started; Insert Cr2032 Battery; Add Water - Oregon Scientific AuraBreeze Manual Del Usuario

LCD DISPLAY SCREEN

1 2
5
6
1. the unit is in volume setting mode
2. the soothing sound is on / the unit is in soothing
sound setting mode
3. Mood light is on / the unit is in mood-light setting mode
4. Diffuser is on / the unit is in diffuser setting mode
5. Alarm is set to on / the unit is in alarm setting mode
6. Sleep timer is on / the unit is in sleep timer setting mode
7. Time display
8. Diffuser low battery display (CR2032)

GETTING STARTED

INSERT CR2032 BATTERY

This unit is equipped with a CR2032 battery as a backup
power source.
1. Open the battery compartment cover by turning it in
anticlockwise using a coin.
2. Insert a CR2032 battery into the compartment,
matching the polarity.
3. Close the battery compartment cover by turning it in
clockwise using a coin.

ADD WATER

NOTE Do not plug the unit to the power outlet before
adding water.
1. Remove the water tank cover, pour tap water in room
temperature into the water tank. Do not exceed the MAX
mark.
3 4
7
8
2. Add few drops of essential oils into the water.
3. Place the cover back in place.
4. Plug the power adapter to the power outlet. Make sure
the adaptor is not obstructed and is easily accessible
to the unit.
5. Press to turn the unit on.
When the water almost runs out (around 50ml remains in
the unit), the diffusing function will stop automatically and
will keep blinking until the unit is turned off.
NOTE
• Do not use distilled water with this product.
• Temperature of water should be around 15 – 40 °C.
• 100% nature essential oil should be used.
• Switch off the unit and unplug from the mains before
moving or cleaning the unit.
• When the water fills up to the MAX marking, the unit
diffuses mist up to 8 hours approximately if the sleep
timer is set to OFF.

CLOCK

SET THE CLOCK

Set the clock when the unit is turned on for the first time.
1. Press to set the 12/24-hour format, hour or minute.
Press and hold
2. Press to confirm.

DIFFUSER

SET THE DIFFUSER

1. Press once to display the current setting. The screen
displays .
NOTE The screen returns to idle if no keys are pressed
after 2 seconds.
2. Press again to toggle different diffusing modes
1 (Low), 2 (High) or OFF.

MOOD LIGHT

SET MOOD LIGHT

1. Press once to display the current setting. The screen
displays .
2. Press again to toggle different mood light setting
(1/2/3/4/5/6/LOOP/OFF).

SOOTHING SOUND

SET SOUND

1. Press once to display the current setting. The screen
displays .
NOTE The screen returns to idle if no keys are pressed
after 2 seconds.
2. Press again to toggle different sound (1/2/3/4/5/6/OFF).
3
to speed up the selection.
–