INSTALLATION INSTRUCTIONS
Connecting drain and electrical
1 Locate the anti-siphon ring shipped with your
washer. Place it over the end of the drain hose and
slide it past the fi rst ring of "accordion" ribs.
2 Form a "U" shape on the end of the drain hose
with the hose pointed toward the drain. Place the
formed end in a laundry tub or a standpipe and
secure the drain hose with the cable tie (provided
in the enclosure package) to the standpipe, inlet
hose, laundry tub, etc. so the hose does not pull
out from the force of the water.
NOTE
The standpipe inside diameter must be 1-1/4" (3.2 cm)
minimum. There must be an air gap around the drain
hose in the standpipe. A snug hose fi t can cause a
siphoning action.
IMPORTANT
Check to ensure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
3 Plug the power cord into a grounded outlet.
Grounding type
Grounding type
wall receptacl
wa
ll receptacle
Po Power cord with
wer cord with
3-prong gr grounded plug
3-prong
ounded plug
4 Turn on the power at a circuit breaker/fuse box.
5 Carefully slide the washer to its fi nal position.
Recheck for level and rock corners for stability.
Remove and discard door tape.
6 Read the Use & Care Guide provided with the
washer. It contains valuable and helpful information
that will save you time and money.
7 Run the washer through a complete cycle, checking
for water leaks and proper operation.
8 If you have any questions during initial operation,
please review the "Service Prevention Checklist" in
your Use & Care Guide before calling for service.
9 Place these instructions in a location near the
washer for future reference.
NOTE
A wiring diagram and technical data sheet are located
under the washer top panel, on top of the detergent
dispenser housing.
10
Do not, under
Do not,
under
an any cir
y circumstances,
cumstances,
cut, remo
cut,
remove ve,
or bypass th
or b
ypass the
gr grounding pr
ounding prong.
ong.
CABLE TIE
ANTI-SIPHON
DISC
SLIDE DISC
TO HERE