Publicidad
Idiomas disponibles
Idiomas disponibles
Leveling your washer
Excessive noise and vibration can be prevented by
properly leveling the washer.
1 For free standing installation and with the washer
within 4 feet (1 m) of its fi nal location, place a level
on top of the washer.
2 Use adjustable pliers to adjust the leveling legs so
the washer is level front-to-rear and side-to-side,
and stable corner-to-corner.
3 Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropriate
leg(s) so the washer sits solidly on the fl oor on
ALL four legs. Keep the leveling leg extension at a
minimum for best performance of the washer.
NOTE
For pedestal installations, see additional installation
instructions included with the pedestal.
Connecting inlet water
1 Run some water from the hot and cold faucets
to fl ush the water lines and remove particles
that might clog the water valve screens and to
determine which faucet is hot and which is cold
supply.
RUBBER WASHERS
MUST BE PRESENT
NOTE
Hoses are not included with washer purchase. See
"Accessories" section for various inlet hose kits to fi t
your specifi c installation.
2 Connect the HOT inlet hose to the HOT inlet
connection on the washer and the COLD inlet
hose to the COLD inlet connection on the washer.
Tighten by hand until snug. Then tighten each
supply connection another 2/3 turn with pliers.
Do not cross thread or over-tighten these
connections.
3 Connect the HOT inlet hose to the HOT water
supply and the COLD inlet hose to the COLD water
supply. Tighten by hand until snug. Then tighten
each supply connection another 2/3 turn with
pliers. Do not bend, kink or pinch water inlet
hoses.
4 Turn on the water and check for leaks.
INSTALLATION INSTRUCTIONS
a
a
USE ONLY
NEW HOSES
HOT
c
c
COLD
e
b
lower
raise
d
b
d
f
g
9
Publicidad
