Descargar Imprimir esta página

Franklin Electric Little Giant PE-1 Guia De Inicio Rapido página 3

Ocultar thumbs Ver también para Little Giant PE-1:

Publicidad

7. Si la unidad se mantiene sin funcionar por un período de tiempo largo, siga
las instrucciones de limpieza descritas en la próxima sección. No permita
que la unidad se congele en invierno. Esto puede causar agrietamiento o
deformaciones, lo cual puede dest ruir la unidad.
8. Si se usa el enchufe con fusible en las unidades de 230V, se recomienda usar
un fusible de 1.0 amperios.
INSTRUCCIONES DE SERVICIO
ASEGURESE DE QUE LA UNIDAD ESTE DESCONECTADA DE LA FUENTA
DE ALIMENTACION ELECTRICA ANTES DE INTENTAR PRESTAR SERVICIO
A LA UNIDAD O QUITAR CUALQUIER COMPONENTE DE ELLA!
1. Esta unidad se encuentra lubricada permanentemente. No se requiere
lubricación. El cable que suministra la corriente a estas unidades no puede
ser reemplazado. En caso de daño, se debe reemplazar la unidad completa.
2. En primer lugar, quite la rejilla de la toma de la bomba. La rejilla se coloca
a presión y puede quitarse tirando de ella. Luego, quite los 3 tornillos que
sujetan el difusor.
3. Limpie ligeramente cualquier corrosión o residuo que pueda ocluir la rueda
móvil. Utilice un cepillo y aceite penetrante, y raspe ligeramente para quitar
el material incrustado.
4. Dé vuelta manualmente a la rueda móvil para verificar que gire libremente.
Coloque la bomba de manera que usted no la toque y que la rueda móvil
no esté tocando nada. Enchufe la unidad en un circuito GFCI durante 10
segundos, para ver si la rueda móvil gira: a) si gira y el GFCI no se desconecta,
desenchufe la unidad e instale las piezas en un orden inverso a aquél en el cual
se quitaron. b) Si no rota, si la bomba desconecta los automáticos o no funciona
debidamente después de la limpieza, regresar a Centro de Servicio Autorizado
Little Giant. NO intente hacer usted mismo las raparaciones.
5. Cerciórese de que el cable eléctrico se encuentre en buen estado y no tenga
muescas ni cortes.
LIMITED WARRANTY
THIS WARRANTY SETS FORTH THE COMPANY'S SOLE OBLIGATION AND PURCHASER'S EXCLUSIVE REMEDY
FOR DEFECTIVE PRODUCT.
Franklin Electric Company, Inc. and its subsidiaries (hereafter "the Company") warrants that the products accompanied
by this warranty are free from defects in materials or workmanship of the Company that exist at the time of sale by the
Company and which occur or exist within the applicable warranty period. Any distributor, sub-distributor, recipient,
end-user and/or consumer agrees that by accepting the receipt of the products, the distributor, sub-distributor, recipient,
end user and/or consumer expressly agrees to be bound by the terms of the warranty set forth herein.
I. Applicable Warranty Period
The products accompanied by this warranty shall be covered by this Limited Warranty for a period of 12 months from
the date of original purchase by the consumer. In the absence of suitable proof of purchase date, the warranty period
of this product will begin to run on the product's date of manufacture.
II. Instructions Applicable to this Limited Warranty
1.
Consumers wishing to submit a warranty claim must return the products accompanied by this warranty to the
point of purchase for warranty consideration.
2.
Upon discovery of a defect, any personal injury, property damage or any other type of resulting damage, if
applicable, shall be reasonably mitigated to the extent possible.
3.
At its discretion, the Company may inspect products either at its facilities, or in the field, and after determination
of a warranty claim, will, at its option, repair or replace defective parts. Repaired or replaced parts will be
returned freight prepaid by the Company.
4.
This warranty policy does not cover any labor or shipping charges. The Company shall not be liable for any
costs or charges attributable to any product testing, maintenance, installation, repair or removal, or for any
tools, supplies, or equipment needed to install, repair, or remove any product.
III. Limitations Applicable to this Limited Warranty
THIS WARRANTY DOES NOT APPLY TO ANY OF THE FOLLOWING:
1.
Brushes, impeller or cam on models with brush-type motors and/or flex-vane impellers.
2.
Any product that is not installed, applied, maintained and used in accordance with the Company's published
instructions, applicable codes, applicable ordinances and/or with generally accepted industry standards.
3.
Any product that has been subject to misuse, misapplication, neglect, alteration, accident, abuse, tampering,
acts of God (including lightning), acts of terrorism, acts of war, fire, improper storage or installation, improper
ADVERTENCIA
REPLACEMENT PARTS • PIÉCES DE RECHANGE • LISTA DE PARTES
pARt
No.
Nº DE
ITEM
PIECE
DESCRIPTIoN
RepeRe
No. DE
NomeNclAtuRe
ARtículo
PIEzA
DESCRIPCIóN
Intake screen • Grille d
1
118901
entrée • Rejilla de la toma
Intake screen • Grille d
1
118911
entrée • Rejilla de la toma
Screw • Vis • Tomillo
2
902417
8-18 X 1" SST
Volute, smooth • Volute à
3
101375
couvercle • Voluta, liso
Volute, hooded • Volute,
3
118340
avec capot • Voluta, con
Capota
3
101333 Volute • Volute • Voluta
Impeller • Rotor •
4
118441
Impulsor
5
101604 Gasket • Joint • Empaque
*
943076 Elbow • Coude • Codo
*Not shown • Non illustré • No se muestra
Note: Only the part numbers shown can be purchased for replacement.
Note: Seules les pièces dont les numéros sont indiqués peuvent être achetées pour remplacement.
NotA: Solamente las piezas con número de referencia pueden adquirirse para repuestos.
use, improper maintenance or repair, damage or casualty, or to an excess of the recommended maximums as
set forth in the product instructions.
4.
Any product that is operated with any accessory, equipment, component, or part not specifically approved by
the Company.
5.
Use of replacement parts not sold by the Company, the unauthorized addition of non-Company products to
other Company products, and the unauthorized alteration of Company products.
6.
Products damaged by normal wear and tear, normal maintenance services and the parts used in connection
with such service, or any other conditions beyond the control of the Company.
7.
Any product that has been used for purposes other than those for which it was designed and manufactured.
8.
Any use of the product where installation instructions and/or instructions for use were not followed.
9.
Products connected to voltage other than indicated on nameplate.
10.
Products where the pump was exposed to any of the following: sand, gravel, cement, grease, plaster, mud, tar,
hydrocarbons, hydrocarbon derivatives (oil, gasoline, solvents, etc.) or other abrasive or corrosive substances.
11.
Products in which the pump has been used to pump or circulate anything other than fresh water at room temperature.
12.
Products in which the pump was allowed to operate dry (fluid supply cut off).
13.
Products in which the sealed motor housing has been opened or the product has been otherwise dismantled
by customer.
14.
Products in which the cord has been cut to a length of less than three feet.
The Company reserves the right at any time, and from time to time, to make changes in the design and/or improvements
upon its product without thereby imposing any obligation upon itself to make corresponding changes or improvements in
or upon its products already manufactured and/or previously sold. The Company further reserves the right to substitute
parts or components of substantially equal quality in any warranty service required by operation of this Limited Warranty.
This written Limited Warranty is the entire warranty authorized and offered by the Company. There are no warranties
or representations beyond those expressed in this document.
THIS WARRANTY AND REMEDY IS IN LIEU OF ALL OTHER WARRANTIES AND REMEDIES INCLUDING WITHOUT
LIMITATION, WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE
HEREBY SPECIFICALLY DISCLAIMED AND EXPRESSLY EXCLUDED. CORRECTION OF NON-CONFORMITIES, IN
THE MANNER AND FOR THE PERIOD OF TIME AS SET FORTH ABOVE, SHALL CONSTITUTE FULFILLMENT OF ALL
LIABILITY OF THE COMPANY TO THE PURCHASER WHETHER BASED ON CONTRACT, NEGLIGENCE, OR OTHERWISE.
CATALoG NUMBER/MoDEL
1
1
1
--
--
--
3
3
3
1
--
1
--
1
--
--
--
--
1
1
1
1
1
1
--
--
--
3

Publicidad

loading