NORTH STATES 8700 Instrucciones página 2

WARNING
• Children have died or been seriously injured when gates are not securely
installed. ALWAYS install and use gates as directed, using all required
parts.
• STOP using when a child can climb over or dislodge the gate.
• Install only with locking/latching mechanism securely engaged.
• To prevent falls, NEVER use at top of stairs.
• NEVER use to keep child away from pool.
• This product will not necessarily prevent all accidents.
• NEVER leave child unattended.
• Periodically check all fasteners to be sure they are tight and secure, stop
using if any parts are missing or become damaged.
• Hardware is included for use in solid materials only, such as wood or metal.
• Never leave anything in the Superyard that could provide a foothold or
create a danger of suffocation or strangulation.
• Do not use Wall Mounts with U-Frame door panel found on models: 8651,
8750, 8751, 8752, 8770, 8772, 8776, 8779.
Your wall mount kit
contains the following:
x8
Screws
To ensure safe operation, additional or replacement parts should be obtained only from North States or
its authorized distributors. Contact information appears on the cover of these instructions.
Replacement parts can be ordered at http://northstatesind.com/main/shop-parts/
Any damage to property during installation of your safety gate is the sole responsibility of the end user.
Installation and Operation
Step 1:
If your yard is already set up as an
enclosure, follow these steps to
disconnect the enclosure. Select
one of the joints where the panel
pushes down (panel 1) See
Figure 1. Gently press down on
panel 1 while lifting slightly on
panel 2. This will enable you to
slide pin "C" free of cylinder D
See Figure 2. Lift up on panel 1
until opening "A" is free of pin "B"
See Figure 3.
x2
Wall
Hinge
FIGURE 1
Pin C D
PANEL 1
Opening A
x1 A B
Mounting
Connector
FIGURE 2
PANEL 1 PANEL 2
PANEL 2
Pin B
Pin C
FIGURE 3
PANEL 1
Slot in
Opening
Cylinder Pin B
A
D
Page 2
PANEL 2