Publicidad
Idiomas disponibles
Idiomas disponibles
Dimensions (LxWxH): 178 x 47 x 57 mm
Weight: approx. 280 g
Emission sound pressure level: Max. 60 dB(A) @ 25 cm
Vibration: < 2.5 m/s2
Charging stand
Dimensions
with accessories (LxWxH): 119 x 91 x 57 mm
Weight: 130 g
Plug-in Transformer
Type Adapter 6000
Power consumption: max. 12 W
Operating voltage: 100 – 240 V AC / 50/60 Hz
Operating conditions
Ambient temperature: 0°C – +40°C
The hair clipper is safety insulated and radio screened. It meets the requirements of EU Electromagnetic
Compatibility Directive 2014/30/EU and Machinery Directive 2006/42/EC.
U.S. Pat. No. D720,888S Clipper
U.S. Pat. No. D758,306S Charger
Operation
Preparation
Keep the packaging material for safe storage or transport later.
• Check that the contents are complete.
• Check all the parts for possible transport damage.
Safety
Caution! Damage due to incorrect power supply.
• Only operate the hair clipper with the voltage stated on the nameplate.
Charging the Battery
This cordless hair clipper is supplied with two battery packs. While the appliance is in use, the second battery pack can be recharged on the charging
stand. This means that the hair clipper is always ready for use.
Before the hair clipper is used for the first time, each battery pack should be charged for the following times:
• STANDARD BATTERY pack approx. 50 minutes
• XXL BATTERY pack (optionally available) approx. 120 minutes.
1. Connect the appliance plug (R) on the plug-in transformer (S) to the plug socket (H) of the charging stand (Fig. 2).
2. Connect the plug-in transformer to the mains socket (Fig. 2).
3. Insert the battery pack into the recess of the charging stand (Fig. 4). The charging process starts.
• During charging, the charging indicator (D) flashes red.
• It should take around 50 minutes for the STANDARD BATTERY pack to charge to full capacity.
• It should take around 120 minutes for the XXL BATTERY pack (optionally available) to charge to
full capacity.
• The second battery can remain in the charging stand so that a charged battery pack is always
available.
4. Once the charging process has finished, the charging indicator (D) lights up green.
Battery Operation
1. Switch on the hair clipper using the on/off switch and switch off after use (Fig. 5).
• In case of insufficient maintenance of the blade set, the operating time can be reduced considerably.
• While in operation with a fully charged battery, the charging indicator (D) lights up green.
• Whenever the charging indicator (D) lights up red during operation, the battery pack needs to be recharged.
You can now use the charged replacement battery pack.
To Recharge the Battery:
1. Switch off the hair clipper using the on/off switch (Fig. 5 ).
2. Press the release button (C) on the side and remove the battery pack (Fig. 3).
3. Remove the charged battery pack (Fig. 4) from the charging stand and slide it into the hair clipper until it locates with an audible click (Fig. 3).
4. Fit the flat battery pack to the charging stand (Fig. 4). See section Charging the battery.
Operation
Setting the cutting length
The cutting length can be adjusted to between 0.7 mm and 3 mm (5 possible positions) using the cutting-length
adjustment (G) integrated into the blade set (Fig. 6).
Publicidad
