Hydrofarm autopilot APCECOD Instrucciones página 6

Q & A
How can I tell if my CO
placing the sensor outdoors for 30 minutes. It should read close to 380 PPM. See the HOW TO
calibrate section.
When I turn on power, the unit says CO
warm up.
Why is the display reading Err SEn? The remote probe is not connected and/or communicating with
the controller. Check the quick-connect cable and that the remote probe is getting power. Contact the
factory for more info.
What if the of the small green error LEDs are on? The CO
Refer to the Error LEDs sections to diagnose the problem.
Why isn't the CO outlet turning on? Verify the correct CO
2
photocell daytime green LED is turned ON.
What if there is no power? RESET the power switch (circuit breaker).
IMPORTANT MESSAGE
1. Save these instructions. These safety and operating instructions must be kept in a safe place for
future reference.
2. Heed all warnings. All warnings on this product and in the instructions must be observed closely.
3. Follow all instructions. All operating instructions must be followed.
4. If the instructions as provided by the manufacturer are not followed, damage to the product may
result.
5. Install your controller at least 8 feet away from any devices that produce large amounts of
electronic noise, such as electronic ballasts or ozone generators.
6. The symbol on the enclosure represents that the receptacle beside it may have an output
voltage, which can be dangerous. The output voltages are the same as the input voltage. This
receptacle can only be inserted with standard Nema 1-15P and Nema 5-15P plugs. Don't insert
any other plug in it.
7. Do not use this Controller near water. For example, near a bathtub, washbowl, kitchen sink, or
laundry tub, in a wet basement, or near a swimming pool, and the like. The controller should not
be exposed to dripping or splashing and no objects filled with liquids, such as vases, should be
placed on this product. The product is not waterproof or shock-proof.
8. Any factory-serviceable spare parts of the product can only be checked or replaced by the
manufacturer or authorized agencies. An unauthorized person is NEVER allowed to open the
enclosure.
6 www.Hydrofarm.com
INSTRUCTIONS
reading is accurate? You can check the calibration of the CO
2
heat? This is normal; it takes 5 minutes for the sensor to
2
sensor or CO device is not acting correctly.
2 2
mode has been selected and/or verify the
2
sensor by
2