Descargar Imprimir esta página

Ruby DN-50EY Manual Del Usuario página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
Cleaning the device
Wipe the dehumidifier with a dry an soft cloth.
To remove heavy dirt, wipe it with a cloth wrung tightly.(Never use a wet cloth
for cleaning the controls).
To avoid deformation or cracking, do not use benzene, thinner or liquid
cleaners.
Chemical cloth may cause the change in color or the unit.
Water tank
Pull out the water tank and take it out. Wash the inside of the tank with water.
The tank may be scratched, if you scrub it strongly with a brush.
Do not remove the float lever from the tank.
Wipe off the water on the outside of tank with a cloth and replace the tank as it
was.
Back & Side Air Intakes (Maintenance every 2 weeks)
The dehumidifying capacity will be lowered when the air clean filter gets clogged.
Remove the back cover from the unit and remove the filter holder. Then take out the air clean filter and
the back filter.
Pull the side cover toward you and remove it from the unit. Remove the side filter from the unit.
To dislodge the dust from these filters, use a vacuum cleaner or pat them lightly.
If the filters are fouled seriously, wash in water including neutral detergent, rinse well with water and
leave until dry.
Pat the air clean filter and is lodge dust from it.
V. SPECIFICATIONS
Model Nº
DN 50 EY
Power Supply
220V-240V~(50Hz)
Dehumidity Capacity:
50 l/d (30ºC /80% HR)
Max. Inout Power
590 W (27ºC / 60% HR)
Max. Input Current
3.65 A (32ºC / 90% HR)
Water tank capacity
8,5 l
The specification may be subject to change without notice for purpose of improvement.
Back filter
Net Weight
Dimensions
Room Temperature
Refrigerant
Fuse
DN-50EY
Air inlet cover
22,5 kg
680 x 460 x 320 (mm)
5ºC – 32ºC
R290/130g
AC250V 3.15 A
13

Publicidad

loading