Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Proper use
The waste and overflow fitting is a combined supply, drain and overflow unit for bath-
tubs with a 52 mm drain hole. It meets the requirements of DIN EN 274.
It is exclusively designed for household wastewater. Introducing other liquids such as
cleaning agents that could damage sanitary equipment, dewatering parts and pipe
materials, especially those with a pH value of less than 4, is not permitted. Installation
must only be performed by technically qualified personnel in compliance with local
building code.
Caution: Safeguard drinking water from contamination. To prevent contamination
of drinking water caused by bath water flowing back into the drinking water system,
a pipe interruptor must be installed between the concealed shut-off fitting and the
bathtub drain. Local standards and regulations must be observed.
The instructions are to be handed out to the owner after the assembly.
A
Duravit
Art. number
791226 00 0 00 1000
791230 00 0 00 1000
B
Parts
Rotatable collar
Fastening flange
O-ring
Profile seal
Overflow
C
Dimensions
Art.-Nr.
791226 00 0 00 1000
791230 00 0 00 1000
Description of product
Drain and overflow set
or water inlet through the drain unit, with rotatable collar
and cover plate, with inlet element,
with odour trap and 45° drainage elbow,
for bathtubs with 52 mm drain hole ø,
quality monitored per DIN EN 274,
with bowden cable length 1070 mm,
with overflow pipe 230 x 450
Description like above, but with overflow pipe 310 x 660
Sleeve
Overflow pipe
Cover plate
Inlet element with
fastening screw
Valve cone
H
[mm]
[mm]
180 - 370
230 - 520
180 - 450
230 - 680
11
Fastening screws
Fastening flange
Profile seal/
double seal
Odour trap
Drainage elbow
L
Publicidad
