Easyconnect FX 1600 garden Instrucciones De Uso página 8

4 – FUNCTIONS « Lighting effects »
With this box many different light effects are possible. The 28
functions of the controller allow the creation of good quality
ambiance to meet all needs...
¤ ON & OFF
¤ INTENSITY : Steady & Variation of Light intensity
With this function the light intensity can be varied from 10% to
100% to create a subdued ambience.
¤ FLASH : Flashing effects
With this function slower or more rapid flashing effects can be
created for lit displays or for Christmas decoration.
¤ SAGA : Progressive effects
With this effect the lighting intensity can be varied with cycles
that are more or less rapid. This allows the progressive lighting
of trees, monuments or other objects that could benefit from
such effect.
¤ OPTION : Scrolling function
This specific function is only possible with those products that
have a scrolling system. The scrolling function makes light
effects run throughout your installation. Several effects and
speed are available.
Use (+) or (–) to vary each function (7 positions pour each
function).
notice-2010_66104.indd 14-15
5 – REPLACEMENT / AQUISITIONS
Simply add, modify or replace transmitters according to your
needs...
Before any acquisition,
ensure that the box and the light are power on
ON/OFF switches
1. Press and hold the "RESET" button on the
control box
2. Press and hold the "FUNCTION" button
on the control box
3. Press twice on the power switch(es) to launch the setup sequence.
4. Release the "RESET" button
5. Release the "FUNCTION" button
Remote control
1. Press and hold the "RESET" button on the
control box
2. Press and hold the "FUNCTION" button on
the control box
3. Press twice on the "ON/OFF" button to launch the setup sequence.
4. Release the "RESET" button
5. Release the "FUNCTION" button
Movement detector
1. Press and hold the "RESET" button on
the control box.
2. Press and hold the "FUNCTION" button on
the control box.
3. Activate signal (Red light)
¤ GREY detector – The signal is activated when the last battery
is inserted
¤ GREY/BLACK detector – The signal is activated by pressing
the button « INIT »
4. Release the button "RESET"
5. Release the button "FUNCTION"
Once the 5 steps are finished,
If acquistion did not ok, renew the 5 steps until obtaining the result.
10/09/2010 09:46:47