1
REAR DRAWBAR
(See Fig. 1A, 1B)
1. Remove existing drawbar by removing four screws.
Insert flat screwdriver to remove bumper from engine
plate. Lift up and pull rearward.
DRAWBAR
ENGINE PLATE
2. Install new drawbar by replacing screws removed in
step 1.
DRAWBAR
Fig. 1A
Fig. 1B
ASSEMBLY
2
REAR MOUNTING BRACKET
(See Fig. 2A and 2B)
NOTE: Your new drawbar already has four (4) shoulder bolts
installed. Simply hang the mounting bracket on the bolts.
SUPPORT
ASSEMBLY
TO REMOVE THE SUPPORT ASSEMBLY (See Fig. 2B)
1. Pull outward on the stop bracket enough to allow support
assembly to be lifted up and away from drawbar.
5
SHOULDER
BOLTS
Fig. 2A
PULL OUT ON STOP
BRACKET TO REMOVE
SUPPORT ASSEMBLY
Fig. 2B