Electrical Components; Hazardous Dust - Milwaukee AS-30 LAC Manual Original

RISKS

Electrical components

DANGER!
The upper section of the machine
contains live components.
Contact with live components leads to
serious or even fatal injuries.
Never spray water on to the upper
section of the machine.
DANGER!
Electric shock due to faulty mains
connecting lead.
Touching a faulty mains connecting
lead can result in serious or even fatal
injuries.
• Do not damage the mains power lead
(e.g. by driving over it, pulling or
crushing it).
• Regularly check whether the power
cord is damaged or shows signs of
ageing.
• If the electric cable is damaged, it
must be replaced by an authorized
Milwaukee distributor or similar
qualifi ed person in order to avoid a
hazard.
• In no circumstances should the power
supply cord be wrapped around
fi ngers or any part of the operators
person.

Hazardous dust

WARNING!
Hazardous materials.
Vacuuming up hazardous materials
can lead to serious or even fatal
injuries.
The following materials must not be
picked up by the machine:
• hot materials (burning cigarettes, hot
ash, etc.)
22 ENGLISH
414 879 - AS-30LAC.indd 22 414 879 - AS-30LAC.indd 22
• fl ammable, explosive, aggressive
liquids (e.g. petrol, solvents, acids,
alkalis, etc.)
• fl ammable, explosive dust (e.g.
magnesium or aluminium dust, etc.)
Spare parts and accessories
CAUTION!
Spare parts and accessories.
The use of non-genuine spare parts, brushes and
accessories can impair the safety and or function of the
appliance.
Only use original spare parts and accessories from
Milwaukee. Spare parts that can aff ect health and safety of
the operator and or function of the appliance, are specifi ed
below:
Description
Flat fi lter PTFE, 1 pcs.
Fleece fi lter bag, 5 pcs.
Disposal bag, 5 pcs.
Motor cooling air fi lter PET, 1 pcs.
In explosive or infl ammable atmosphere
CAUTION!
This machine is not suitable for use in explosive or
infl ammable atmospheres or where such atmospheres are
likely to be produced by the presence of volatile liquid or
infl ammable gas or vapour.
CONTROL / OPERATION
CAUTION!
Damage due to unsuitable mains voltage.
The appliance can be damaged as a result of being
connected to an unsuitable mains voltage.
• Ensure that the voltage shown on the rating plate
corresponds to the voltage of the local mains power supply.
Starting and operating of the machine
Check that the electrical switch is switched off (in position
0). Check that suitable fi lters are installed in the machine.
Then connect the suction hose into the suction inlet at the
machine by pushing the hose forward until it fi ts fi rmly in
place at the inlet. Then connect the tubes with the hose
handle, twist the tubes in order to ensure that they are
properly fi tted. Attach suitable nozzle to the tube. Choose
nozzle depending on what type of material that is to be
picked-up. If used for dust extraction in connection
with dust producing tool then connect end of suction hose
with appropriate adapter. Connect the plug into a proper
electrical outlet. Put the electrical switch into position I in
order to start the motor.
Order No.
4932 4596 87
4932 459689
4932 4596 90
4932 4596 88
27.07.2017 11:15:22 27.07.2017 11:15:22