Hazards Caused By Flying Parts - Parkside PDBS 1800 A1 Traducción Del Manual De Instrucciones Original

■ Keep work area clean and well lit . Cluttered or
dark areas invite accidents . This enables better
control of the tool in unexpected situations .
WARNING!
► Have your tool serviced by qualified trained
personnel using only original spare parts .
This ensures that the safety of the tool is
maintained .
■ Keep children and other persons away from the
tool during operation . Distractions can cause
you to lose control .
■ Dress properly . Do not wear loose clothing or
jewellery . Keep your hair, clothing and gloves
away from moving parts . Loose clothes, jewel-
lery or long hair can be caught in moving parts .
■ Put the trigger and the tool away in the case of
an unexpected stoppage of the compressor .
■ Wherever possible, use a condensate separator
or drain the condensate (water) from the hoses
and tubing regularly before and during the use
of the compressed-air tools .
■ NOTICE! An undersized compressed-air system
will reduce the efficiency of your tool .
■ Please ensure that you have read and under-
stood the safety instructions regarding multiple
hazards before installation, operation, repair,
service and replacement of any accessories
and before work near the automatic screwdriver .
Otherwise, there is a risk of serious physical
injuries .
■ The automatic screwdriver should only be
fitted, adjusted or used by qualified and trained
operators .
■ 38 │ GB │ MT
■ The automatic screwdriver may not be modified .
Modifications can reduce the effectiveness of
the safety measures and increase the risks for
the operator .
■ Do not lose the safety instructions – hand them
to the operator .
■ Never use a damaged machine on screwed
joints .
■ The machines must be serviced regularly to
check whether the rated values and markings
required in the present part of ISO 11148 are
appended legibly on the machine . The employ-
ee/operator must contact the manufacturer to
obtain replacement stickers for labelling if this is
necessary .

Hazards caused by flying parts

■ If a workpiece or one of the accessory parts or
even the machine tool itself breaks, parts can
be thrown off at high speeds .
■ Always wear impact-resistant safety goggles
during operation, when replacing accessory
parts or during repair or maintenance work .
The level of the required protection must be
evaluated separately for each individual task .
■ The wrench must be removed before drilling
begins .
■ Ensure that the workpiece has been securely
fixed in place .
■ Check regularly that the rotation speed of
the compressed-air tool is not higher than the
specified rotation speed appended on the
compressed-air tool . These rotation speed tests
must be conducted without any accessory tools
attached .
■ Ensure that sparks and fragments created
during work do not constitute a hazard .
■ Separate the compressed-air tool from the
compressed-air supply before replacing the
attachment or accessories or before you adjust
the settings, service or clean the tool .
■ Ensure that no dangers are created for other
persons either .
PDBS 1800 A1