Publicidad
Start assistance
1. Ensure that the vehicle is not running and switch it off at the ignition.
2. Warning: Do not allow both battery clamps (7) to touch one another and do not short circuit
them.
3. Connect the red clamp with the plus pole on the battery.
4. Connect the black clamp with a fixed metal part in the engine space (mass), but never with
the MINUS pole of the battery.
5. Make sure that the clamps are firmly attached.
6. Switch on the quick-start system by pressing the main switch (1) and wait for 3-5 minutes.
7. Switch on the vehicle ignition.
8.
max. 5-6 seconds.
Start the engine for
9. If the engine does not start, wait at least 3 minutes before repeating the process.
10. Once the engine is running, remove the black battery clamp and fasten it to the housing of
the quick-start system.
11. Then, remove the red clamp from the battery and fasten it to the housing.
12. At your next opportunity, charge the quick-start system so that you can continue using it.
You can only use the start assistance function if the quick-start system is fully
charged.
13. The quick-start system is not suitable for starting completely discharged batteries.
Use as a 12 V= power source
WARNING: The 12 V output (1) provides a 12 V direct current, even if the main switch (5) is not
switched on.
1. Remove the cover from the 12 V socket (1).
2. Insert the plug into the socket and connect the free end with the 12 V device connection.
USB output
Small devices can be operated with the USB plug at the USB port (6). The USB port supplies 5
volts with up to max. 2000 mA and is not a data port. Operational readiness is indicated by the
green LED.
Use as a compressor
1. To pump up tires, pin the connection into the valve and flip the clamp lever.
2. To pump up balls or other sport or leisure items, first place the corresponding valve adapter
(14) in the connector and fasten it by flipping the clamp lever.
3. Switch on the compressor (9).
4. Using the manometer (10), check the pressure reached and switch off the compressor once
the required pressure has been reached.
5. Allow the compressor to run for a maximum of 10 minutes. If you require a greater volume of
air, allow the compressor to cool off for approx. 10 minutes before continuing the pump
process.
Publicidad
