Proper Use - DURAVIT 791228 00 0 00 1000 Manual De Instrucciones

GB

Proper use

The waste and overflow fitting is a combined supply, drain and overflow unit for bath-
tubs with a 52 mm drain hole. It meets the requirements of DIN EN 274.
It is exclusively designed for household wastewater. Introducing other liquids such as
cleaning agents that could damage sanitary equipment, dewatering parts and pipe
materials, especially those with a pH value of less than 4, is not permitted. Installation
must only be performed by technically qualified personnel in compliance with local
building code.
Caution: Safeguard drinking water from contamination. To prevent contamination
of drinking water caused by bath water flowing back into the drinking water system,
a pipe interruptor must be installed between the concealed shut-off fitting and the
bathtub drain. Local standards and regulations must be observed.
The instructions are to be handed out to the owner after the assembly.
A
Duravit
Art. number
791228 00 0 00 1000
791235 00 0 00 1000
B
Parts
Rotatable collar

Fastening flange

O-ring

Profile seal

Overflow

C
Dimensions
Art.-Nr.
791228 00 0 00 1000
791235 00 0 00 1000
560422_Duravit.indd 11
Description of product
Drain and overflow set
or water inlet through the drain unit, with rotatable collar
and cover plate, with inlet element, with odour trap,
for bathtubs with 52 mm drain hole ø, quality monitored per DIN EN 274,
with bowden cable length 725 mm
Description like above, but with bowden cable length 1070 mm
Sleeve

Overflow pipe

Cover plate

Inlet element with

fastening screw
Valve cone

H L
[mm] [mm]
180 - 430 130 - 370
180 - 480 100 - 680
11
Fastening screws
 
Fastening flange

Profile seal/

double seal
Odour trap

Drainage elbow

Flexible drain pipe
27.11.2013 09:40:02