Teka HSB Serie Manual De Instrucciones página 31

temperatures reached inside the oven, accu-
mulated grease undergoes a carbonisation
process.
The general recommendation is to perform a
pyrolytic cycle every 4-5 uses, using the most
suitable programme according to the level of
stains present in the oven. The more stained
the oven, the longer the duration of the pro-
gramme.
During the pyrolytic cycle the light inside the
oven will remain off.
PROGRAMMING
THE PYROLYTIC FUNCTION
IMPORTANT
Before carrying out the pyrolysis, you must
remove all accessories and dishes from the
oven, including the shelves and/or telescop-
ic guide rails. To do this, follow the instruc-
tions in the installation and maintenance
guide accompanying the oven.
WARNING
Clean any spillages or excess dirt from the
inside, as these could ignite during the py-
rolysis and create a fire hazard.
WARNING
Before running the pyrolytic function, ensure
that the oven is properly closed.
1. Turn the cooking control dial to the Pyrolysis
position .
2. TAfter a few seconds, the
light up on the clock display, reading 'P2'
(Pyrolysis programme 2.
3. You can now change the pyrolysis pro-
gramme to P1, P2 or P3 by pressing the
or keys:
P1: Light pyrolysis. Lasts 1 hour.
P2: Regular pyrolysis. Lasts 1 hour 30 min.
P3: Intensive pyrolysis. Lasts 2 hours.
4. Once the desired programme has been se-
lected, press
will be activated immediately.
If the door is not properly closed, it will not
lock and an alarm will sound.
If this happens, switch off the alarm by
pressing any clock button, close the door
properly, turn the function dial to the
sition and re-select the pyrolytic programme
as described above.
5. Once the door is locked, the
up on the clock display and the time remaining
before the end of the pyrolysis will appear.
At this point, the oven is programmed and
the pyrolytic cleaning cycle is under way.
During the cycle, none of the oven timer
functions may be chosen (except the child
lock).
Do not try to open the oven door as this may
interrupt the cleaning process.
6. When the pyrolytic cleaning cycle has fin-
ished, an alarm will sound, the
will flash and you will see the time '0:00' on
the clock display.
7. Press any of the timer's keys to disable the
alarm.
8. Turn the control dial to the
symbol will
9. The oven's heating process has finished.
However, the oven is extremely hot and can-
not be used.
The cooling process will continue to oper-
ate and the
oven cools down.
. The automatic door lock
WARNING
IMPORTANT
symbol will remain lit until the
English
po-
symbol will light
symbol
position.
31
User's Guide