Makita HM1512 Manual De Instrucciones página 6

Installing the bit
CAUTION:
Always assure that the bit is securely
retained by attempting to pull the bit out of the tool
holder after completing the above procedure.
This tool accepts bits either with or without a collar on its shank.
1
► 1 . Bit with collar 2. Bit without collar
To install the bit, follow either procedure (1) or (2) described below.
NOTICE:
The bit without a collar cannot be retained
by procedure (1).
(1) For bits with a collar
Pivot the tool retainer as shown in the figure.
Insert the bit into the tool holder as far as it will go.
When inserting the bit
► 1 . Bit 2. Tool retainer 3. Tool holder
To secure the bit, return the tool retainer as shown in the figure.
When the bit is retained
► 1 . Bit 2. Tool retainer
(2)
When inserting the bit
2
► 1 . Bit 2. Tool retainer 3. Tool holder
When the bit is retained
1
2
► 1 . Bit 2. Tool retainer
3
Removing the bit
To remove the bit, follow the installation procedure in
reverse.
1
2
6 ENGLISH
For bits without a collar
Pivot the tool retainer as shown in the figure.
With the notched portion of the bit facing the tool
retainer shaft, insert the bit into the tool holder as
far as it will go.
To secure the bit, pivot the tool retainer as shown
in the figure.
1
2
3
1
2