Briggs & Stratton 310000 Extended Life Serie Manual Del Operario página 9

Ocultar thumbs Ver también para 310000 Extended Life Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. Install air filter cover and secure with fasteners.
How To Replace The Fuel Filter - Figure 12
WARNING
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition
sources.
Check fuel lines, tank, cap, and fittings frequently for cracks or leaks.
Replace if necessary.
Before replacing the fuel filter, drain the fuel tank or close the fuel shut-off valve.
Replacement parts must be the same and installed in the same position as the
original parts.
If fuel spills, wait until it evaporates before starting engine.
1. Before replacing the fuel filter (A, Figure 12), if equipped, drain the fuel tank or close
the fuel shut-off valve. Otherwise, fuel can leak out and cause a fire or explosion.
2. Use pliers to squeeze tabs (B) on the clamps (C), then slide the clamps away from
the fuel filter. Twist and pull the fuel lines (D) off of the fuel filter.
3. Check the fuel lines for cracks or leaks. Replace if necessary.
4. Replace the fuel filter with an original equipment replacement filter.
5. Secure the fuel lines with the clamps as shown.
How To Clean The Air Cooling System - Figure 13
WARNING
Running engines produce heat. Engine parts, especially muffler,
become extremely hot.
Severe thermal burns can occur on contact.
Combustible debris, such as leaves, grass, brush, etc. can catch fire.
Allow muffler, engine cylinder and fins to cool before touching.
Remove accumulated debris from muffler area and cylinder area.
Engine Specifications
Model
Displacement
Bore
Stroke
Oil Capacity
Tune-up Specifications *
Model
Spark Plug Gap
Spark Plug Torque
Armature Air Gap
Intake Valve Clearance
Exhaust Valve Clearance
* Engine power will decrease 3.5% for each 1,000 feet (300 meters) above sea level and 1% for each 10 F (5.6 C) above 77 F (25 C). The engine will operate satisfactorily at an
angle up to 15. Refer to the equipment operator's manual for safe allowable operating limits on slopes.
Service Part
Air Filter, Oval
Air Filter Pre-cleaner, Oval
Oil -- SAE 30
Oil Filter, Standard -- Black
Oil Filter, High Efficiency -- Yellow
Oil Filter, High Efficiency -- Orange
Fuel Filter
n We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts.
en
Specifications
310000
30.52 ci (500 cc)
3.563 in (90.49 mm)
3.062 in (77.77 mm)
46 -- 48 oz (1.36 -- 1.40 L)
310000
0.030 in (0.76 mm)
180 lb-in (20 Nm)
0.010 - 0.014 in (0.25 - 0.36 mm)
0.003 - 0.005 in (0.08 - 0.13 mm)
0.005 - 0.007 in (0.13 - 0.18 mm)
Common Service Parts n
Part Number
793569
793685
100028
492932
795890
798576
394358S
NOTICE: Do not use water to clean the engine. Water could contaminate the fuel
system. Use a brush or dry cloth to clean the engine.
This is an air cooled engine. Dirt or debris can restrict air flow and cause the engine to
overheat, resulting in poor performance and reduced engine life.
Use a brush or dry cloth to remove debris from the finger guard/rotating screen (A).
Keep linkage, springs and controls (B) clean. Keep the area around and behind the
muffler (C) free of any combustible debris (Figure 13).
Storage
WARNING
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
When Storing Fuel Or Equipment With Fuel In Tank
Store away from furnaces, stoves, water heaters or other appliances that have
pilot lights or other ignition sources because they can ignite fuel vapors.
Fuel System
Fuel can become stale when stored over 30 days. Stale fuel causes acid and gum
deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh,
use Briggs & Stratton Advanced Formula Fuel Treatment & Stabilizer, available
wherever Briggs & Stratton genuine service parts are sold.
There is no need to drain gasoline from the engine if a fuel stabilizer is added according
to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel
system before storage.
If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into
an approved container. Run the engine until it stops from lack of fuel. The use of a fuel
stabilizer in the storage container is recommended to maintain freshness.
Engine Oil
While the engine is still warm, change the engine oil.
Troubleshooting
Need Assistance? Go to BRIGGSandSTRATTON.COM or call 1-800-233-3723 in USA.
Engine Specifications
Model
Displacement
Bore
Stroke
Oil Capacity
Tune-up Specifications *
Model
Spark Plug Gap
Spark Plug Torque
Armature Air Gap
Intake Valve Clearance
Exhaust Valve Clearance
Service Part
Advanced Formula Fuel Treatment & Stabilizer
Resistor Spark Plug
Long Life Platinum Spark Plug
Spark Plug Wrench
Spark Tester
330000
32.93 ci (540 cc)
3.701 in (93.99 mm)
3.062 in (77.77 mm)
46 -- 48 oz (1.36 -- 1.40 L)
330000
0.030 in (0.76 mm)
180 lb-in (20 Nm)
0.010 - 0.014 in (0.25 - 0.36 mm)
0.003 - 0.005 in (0.08 - 0.13 mm)
0.005 - 0.007 in (0.13 - 0.18 mm)
Part Number
5442
491055
5066
89838, 5023
19368
9

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

310000 professional serie330000 intek330000 extended life series330000 professional series330000 extended life serie330000 professional serie

Tabla de contenido