Kit Preparation; Kit Assembly - Metra 95-7353CH Guia De Instalacion

Kit Preparation

1. Mount the a/c vents, storage pocket,
hazard switch, and passenger air
bag indicator into the Radio Housing
Trim Panel using screws removed in
disassembly. (Figure A)
Note: For models without an airbag light,
a blank plate and (3) #8 x 3/8" Phillips
Truss-Head Screws are provided.
2. Mount the start/stop switch or blank
plate depending on your application
into the Radio Housing Trim Panel.
Note: An airbag-light
blank plate and screws
are included for
non-US models.
(Figure A)
Note: If no switch is present there are
(2) #8 X 3/8" Phillips truss head screws
supplied to mount the blank plate.
3. Install the (8) panel clips removed
in disassembly onto the Radio
Housing Trim Panel.
Continue to kit assembly
95-7353CH
ISO DDIN radio provision
1. Mount the radio to the radio
brackets using the screws supplied
with the radio. (Figure A)
2. Mount the radio/bracket assembly
into the dash.
3. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
4. Reassemble the dash in reverse
order of disassembly.
3

Kit Assembly

(Figure A)