Publicidad
Idiomas disponibles
Idiomas disponibles
For A. D. A. compliance, top of lower double stud should be
30.5" (78 cm) from the floor.
Recommended Blocking:
Wood double stud blocking is necessary. Contact an architect and
building official to make sure the blocking is adequate and complies
with building codes (Fig. b).
1. Slide changer into blocking area and mark mounting hole location
on blocking studs.
HINT: This may require 2 additional people to help hold changer
in position while you are marking the locations.
2. Shim changer for a snug fit.
3. Align holes in changer with marked holes and secure using the
appropriate fasteners (Fig. c).
NOTE: It is installers responsibility to provide correct fastereners
for other substrates.
4. Ensure all six (6) fasteners are tight.
Recommended Blocking:
If the walls do not have studs on center, then additional blocking is necessary
(Fig. d).
Contact an architect or building contractor to make sure the blocking is ad-
equate
and complies with building codes.
For A. D. A. compliance, measure up 62 3/4" (159 cm) from the floor and mark
the wall. This locates the position for the top left attachment hole.
NOTE:
- Changer MUST be mounted to studs (Fig. e).
- This unit incorporates a finishing collar that seats behind the chang-
er's
outside flange. Center the collar as the unit is being tightened against
the wall (Fig. f).
INSTALLATION - RECESSED
INSTALLATION - SURFACE-MOUNT
For A. D. A.
Compliance
28.5"
(72 cm)
A. F. F
Recess
Mounting
Holes
For A. D. A.
Compliance
60.5"
(154 cm)
Collar
Wall
Unit
Fig. f
2
22-1/2"
(571 mm)
3-7/8"
(98.6 mm)
22-1/2" (571 mm)
Rough-in
Double Stud
34-1/8"
(867 mm)
Rough-in
30-1/2"
(775 mm)
Double Stud
Fig. b
Recess
Mounting
Holes
Fig. c
Top
16"
26"
(406 mm)
(660 mm)
on center
on center
A. F. F
Fig. d
Surface-Mount
Holes
Fig. e
TOP
VIEW
FRONT
VIEW
Recess
Mounting
Holes
Publicidad
