Wolf SW 24 Manual Del Usuario página 10

WOLF SW 24: CONTROL BOARD FOR SWING GATES
DIGITAL TIME PROGRAMMING AND AUTOMATIC CLOSURE
DIGITAL PROGRAMMING OF MANEUVER TIME WITH THE COMMAND
1. - Record two buttons of the remote on the "RX MULTI" receiver on the control board. The
first button will be recorded in "CHANNEL 2" and will control the master gate. And the
second button will be recorded in "CHANNEL 1" and will control the slave gate.
2. - Once we have made step 1, press the "PROG TIME" button on the control board, the led
will remain fixed (programming is open).
3. - Press "BUTTON 1" of the remote the master door will begin to open. Wait for a time and
press "BUTTON 2", the slave door will begin to open.
4. -Press again the "BUTTON 1" to start the soft stop at the master door, and press "BUTTON 2"
to start the soft stop is slave door. (This function only works if the "SOFT STOP" option is
activated (option 7).
5. - Press "BUTTON 1" again to finish the maneuver of opening in the master door and press
"BUTTON 2" to finish the maneuver of opening in the slave door.
10