Rear Panel - Peavey CEL 2 Manual De Instrucciones

REAR PANEL

INPUT AND OUTPUT JACKS:
(16) BALANCED OUTPUT: XLR servo balanced output. The nominal level (when the output meter
is at 0 dB) is +4 dBu. (Pin 2 is positive in phase).
(17) UNBALANCED OUTPUT: 1/4" unbalanced output. If this jack is used, the input/output TRS
jack (#18) becomes an input only (tip) jack. The nominal level is 0 dBu.
(18) DETECTOR SIDE CHAIN INSERT: 1/4" stereo (TRS) jack which allows an external device
(such as a graphic EQ) to be inserted into the detector's signal path. The tip has the send signal, the
ring is the return input. A switch in the jack normally connects the return (ring) to the other
channel's send (tip) until a plug is inserted. This gives ducking capabilities without patching.
(19) INPUT/OUTPUT: A dual function 1/4" TRS jack that has both input and output signals config-
ured so that a standard (not cross wired) stereo shielded cable can be used to plug into the TRS
insert of a mixer. (The tip is the compressor input, the ring is the output, which match the insert jack
wiring of all current Peavey mixers.) If the unbalanced output jack (#17) is used, the ring connection
(output) of this jack is disconnected, and it becomes an input only jack (tip). The nominal levels are
0 dBu.
(20) BALANCED INPUT: XLR balanced input for +4 dBu (nominal) line level inputs. Pin 2 is the
positive phase, pin 3 is the negative phase.
(21) A/C POWER INLET: This is the receptacle for an IEC line cord, which provides AC power to
the CEL 2. Connect the line cord to this connector to provide power to the unit. Damage to the
™
equipment may result if improper line voltage is used (see line voltage marking on unit).
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the col-
ored markings identifying the terminals in your plug, proceed as follows: (1) The wire which is
colored green and yellow must be connected to the terminal which is marked by the letter E or by
the earth symbol or colored green or green and yellow. (2) The wire which is colored blue must be
connected to the terminal which is marked with the letter N or the color black. (3) The wire which is
colored brown must be connected to the terminal which is marked with the letter L or color red.
21
16 17 18 19 20
6
16 17 18 19 20