VOSKER V100 Guia De Inicio Rapido página 10

1. Turn the camera ON
Use the ON/OFF switch to turn the camera ON.
2. All lights flashing - Searching for signals
signal strength and restart the camera. This operation might need
to be repeated as the VOSKER SIM card and services are powered
by multiple providers. The network modem will maneuver to
ensure strongest signal strength by searching for the best tower
available (cell network).
3. Solid blue bars - Signal strength
shown on other cellular devices as there is no industry standards
and practice to label DBM values to a specific number of bars.
4. Red light flashing (30 s) - Installation delay
The test light in front of the camera will flash for 30 seconds to
allow the user to leave the area without being photographed or
recorded.
5. All lights OFF - Camera ready
The camera has sent a picture and updated its status in the
VOSKER app with its latest information. The camera is now ready
to take pictures and transmit them to your VOSKER app upon
the next synch. Synchs are set by default to every 4 hours from
midnight.
Note: If your camera did not send the photo and/or the
status in the 15 minutes following the completion of
the last step. Please turn OFF the camera and perform
the steps 1 to 5 again. If the problem persists, please
consult the Help section of your VOSKER APP.
10
The signal search can take few minutes to process. If
only 1 blue bar is flashing, the network test was un-
successful. Get outside or near a window to maximize
Once the network test is completed, blue bars will
stabilize showing the signal strength. Note that signal
bars displayed on the camera can differentiate of those
Help