Connecting Analog Inputs - Klein + Hummel KPA Serie Manual Del Usuario

■

Connecting Analog Inputs

Analog Input connections are made via the 3-pin XLR-female type or 1/4" phone Jack connectors on the rear side of
the amplifier. The polarity is shown in
The figure below shows the connection of analog input for balanced and unbalanced line. You can use both
configuration, but you must consider that unbalanced long line can introduce noise in the audio system. The Link
switch located in the rear panel is for direct paralleling the rear input connectors. You can use the remaining input
connector to carry signal to other amps.
Operating Manual KPA Series
figure 4
.
GND
IN(-)
IN(+)
Balanced input
figure 4
Unbalanced input
figure 5
English
Klein + Hummel
/
SHIELD
IN(+)
9