Fcc Notice - Naxa NPD-1004 Manual De Operación

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
C O V E R ( O R B A C K ) . N O U S E R -
SERVICEABLE PARTS INSIDE. REFER
S E RV I C I N G TO Q U A L I F I E D S E RV I C E
PERSONNEL.
The lightning flash with arrowhead
symbol within an equilateral triangle
is intended to alert the user to the
presence of uninsulated dangerous
voltage within the product`s enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended
to alert the user to the presence
o f i m p o r t a n t o p e r a t i n g a n d
maintenance(servicing) instructions in the
literature accompanying the appliance.
DANGER:
Invisible and hazardous laser
radiation when open and interlock
failed or defeated. Avoid direct
exposure to beam.
CAUTION:
T H I S D I G I TA L V I D E O D I S C P L AY E R
EMPLOYS A LASER SYSTEM.
T O E N S U R E P R O P E R U S E O F T H I S
PRODUCT.
PLEASE READ THIS OWNER`S MANUAL
CAREFULLY AND RETAIN FOR FUTURE
R E F E R E N C E . S H O U L D T H E U N I T
REQUIRE MAINTENANCE, CONT ACT AN
AUTHORIZED SERVICE LOCATION-SEE
SERVICE PROCEDURE.
U S E C O N T R O L S , A D J U S T M E N T S O R
THE PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
TO PREVENT DIRECT EXPOSURE TO
LASER BEAM, DO NOT TRY TO OPEN THE
ENCLOSURE. VISIBLE LASER RADIATION
MAY BE PRESENT WHEN THE ENCLOSURE
IS OPENED. DO NOT STARE INTO BEAM.
WARNING:
T O R E D U C E T H E R I S K O F F I R E O R
ELECTRIC SHOCK, DO NOT EXPOSE THIS
PRODUCT TO RAIN OR MOISTURE.
WARNING:
T O R E D U C E T H E R I S K O F F I R E O R
E L E C T R I C S H O C K , A N D A N N O Y I N G
INTERFERENCE, USE THE RECOMMENDED
ACCESSORIES ONLY.
SURGE PROTECTORS:
It is recommended to use a surge protector for
AC connection. Lightning and power surges
ARE NOT covered under warranty for this
product.

FCC NOTICE:

Warning:Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment."
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
r e a s o n a b l e p r o t e c t i o n a g a i n s t h a r m f u l
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not Installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.
H o w e v e r, t h e r e i s n o g u a r a n t e e t h a t
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
● R e o r i e n t o r r e l o c a t e t h e r e c e i v i n g
antenna. Increase the separation between
the equipment and receiver.
Increase the separation between the equi-
pment and receiver.
● Connect the equipment into an outlet
on a circuit different from that to which the
receiver is connected.
● Consult the dealer or an experienced
radio/TV technician for help.
2