Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREW IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
HARDWARE NEEDED
#8 x 1 7/16
21
Sheet Metal Screw
(Qty. 6)
#8 x 7/16
Sheet Metal Screw
(Qty. 18)
8. Lay out Right Side Rails #25, Left Side Rails
#29 and End Rails #26, around edges of
table top as shown in Figure 6.
9. Slide Left #36 and Right #35 Vinyl End
Caps onto the ends of the Side Rails #25
& 29 as shown in Detail E1 & E2.
10. Line up holes in rails with indentations in
top and secure using eighteen screws
#20. See Figure 6 & Detail E1 & E2.
11. Lay Corner Caps #22 on table as shown
in Figure 6. If Corner Cap sticks above
the table top surface of the table, flip
over so shorter distance is against edge.
Secure to bottom of table with three
Screws #21. See Detail F.
Note: Prince
logo must be on
this end of Rail.
29
(LH Rail)
20
20
36 (LH)
Detail E1
8
Note: Rails attach
with #20 screws
20
26
Detail F
Note: Prince
logo must be on
this end of Rail.
25
(RH Rail)
20
35 (RH)
Detail E2
Publicidad
