Braun 3 Serie Manual Del Usuario página 12

Before discarding the used cartridge, make sure to close the openings using
the lid of the new cartridge, since the used cartridge will contain contami-
nated cleaning solution.
The used cartridge can be disposed in the household waste.
Operating your Clean&Renew
• Connect your Clean&Renew with the cord set to the mains electricity
supply. The special socket at the back is adjustable to save space. After
each shave, switch the shaver off and put it into the Clean&Renew, upside
down and with the front showing.
• Push the start/release button (1) to lock and connect the shaver. The
cleaning process will start. The yellow light on the shaver will flash during
the complete process (approx. 2 minutes cleaning, min. 4 hours drying).
• Do not interrupt the cleaning process, as it leaves the shaver wet and not
fit for use. If interruption is needed nonetheless, press the start/release
button (1).
• When cleaning is finished, the yellow light will go off and the shaver is
ready for use. To release it, push the start/release button.
• A cleaning cartridge should be sufficient for about 30 cleaning cycles.
When the level indicator (4) has reached the «
fluid in the cartridge is sufficient for about 5 more cleaning cycles. Then
the cartridge should be replaced, when used daily approx. every 4 weeks.
• The hygienic cleaning solution cartridge contains alcohol which, once
opened, will naturally evaporate slowly into the surrounding air. Each
cartridge, if not used daily should be replaced after approx. 8 weeks.
• The cleaning cartridge also contains lubricates, which may leave residual
marks on the shaver head after cleaning. However, these marks can be
removed easily by wiping gently with a cloth or soft tissue paper.
• Clean the housing from time to time with a damp cloth, especially the
opening where the shaver rests.
Accessories
Available at your dealer or Braun Service Centers:
• Foil & Cutter cassette: 32S/32B
• Cleaning cartridge Clean&Renew: CCR
Subject to change without notice.
For electric specifications, see printing on the special electric cord set.
12
» mark, the remaining