Descargar Imprimir esta página

Billy Goat PW30AOV Guía De Configuración Rápida página 3

Ocultar thumbs Ver también para PW30AOV:

Publicidad

Idiomas disponibles

Idiomas disponibles

PW30AOV QUICK SETUP GUIDE
CONNECT WATER SUPPLY
1. Inspect garden hose inlet screen (K) for damage. (See Fig. 8)
NOTE: If inlet screen is damaged or missing, DO NOT use pressure washer, call 1-
800-770-7690.
2. Run cold water through garden hose (L) for 30 seconds to clean out any debris.
Garden hose length must not exceed 50 ft. (15 m). Turn off water supply and attach
garden hose to water hose inlet (M). Tighten by hand. (See Fig. 8)
START PRESSURE WASHER
NOTE: You MUST connect and turn on water supply fully before starting engine.
WARNING Risk of eye injury. Spray could splash back or propel objects
resulting in serious injury. Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using or in vicinity of this
equipment. NEVER substitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
1. Put on safety goggles.
2. Turn on water supply.
3. Point gun in a safe direction and press red safety button (N) on spray gun and pull
trigger until water comes out in a steady stream. (See Fig. 9)
4. Attach nozzle extension (P) to spray gun (H). Tighten by hand. (See Fig. 10)
5. Choose desired quick-connect spray tip (R), pull back on collar of nozzle extension
(P), insert spray tip and release collar. Tug on spray tip to make sure it is securely
in place. (See Fig. 11)
6. Move fuel valve lever (S) to "On" position. (See Fig. 12)
7. Move throttle lever (T) to "Fast" position, shown as a rabbit. (See Fig. 13)
8. Move choke lever (U) to "Closed" position. (See Fig. 14)
NOTE: For a warm engine, be sure the choke lever is in the "Open" position.
WARNING Starter cord kickback (rapid retraction) will pull hand and arm toward
engine faster than you can let go which could cause broken bones, fractures,
bruises, or sprains resulting in serious injury. NEVER pull starter cord without first
relieving spray gun pressure. Pull starter cord slowly until resistance is felt, then pull
rapidly. Firmly grasp spray gun with both hands when using high pressure spray to
avoid injury when spray gun kicks back.
9. When starting engine, position yourself as shown. Grasp starter grip handle and pull
slowly until you feel some resistance. Then pull rapidly to start engine. (See Fig.
15)
10. When engine starts, slowly move choke lever to "Open" position as engine warms.
If engine falters, move choke lever to "Closed" position, then to "Open" position.
11. If engine fires, but does not continue to run, always point gun in safe direction,
press red safety button and squeeze spray gun trigger to release high-pressure.
Move choke lever to "Open" position, and repeat steps 10 through 11.
12. If engine does not start after six pulls, move choke lever to "Open" position, and
repeat steps 10 through 11.
NOTE: Always keep the throttle lever in the "Fast" position when operating the
pressure washer.
13. Point gun toward surface to be cleaned. Press red safety button and pull trigger to
begin spraying.
Part No 210501
L
3
Fig. 7
J
K
M
G
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Form No F120115A

Publicidad

loading

Este manual también es adecuado para:

210501