REV Ritter 00716 Manual Del Usuario página 9

Read this manual carefully before using this product and check whether there are any damaged parts. The
product has not to be installed in case of damages. Keep this product out of reach of children or any
unauthorized persons. At the end of its lifetime, dispose of the product correctly. Electronic components
have to be disposed of as no standard landfill.
This product has been developed according to the latest technology. You are obliged to install it according to
the valid regulations or to have it installed by a qualified expert. The entire manual has to be followed when
installing and using this products. This manual is subject to technical changes.
The packaging includes:
!
Halogen floodlight projector with movement detector 150W
!
Suitable bulb
How a movement detector works
Movement detectors are electronic devices turning on and off. They are equipped with a lens recording thermal
radiation. When the origin of this thermal radiation changes its location or starts moving, the movement
detector activates the integrated halogen floodlight projector for an adjustable time. The starting time begins
when the origin to the thermal radiation stops moving.
The movement detector works at daylight as well as at night. By turning a switch, one can adjust directly the
brightness from which the movement detector activates the halogen floodlight projector.
How to adjust your movement detector
The switching duration can be adjusted with the timer switch (TIME) directly for a duration between 5 seconds
approx. and 8 minutes approx.
The brightness (DAYLIGHT) when the device turns on and off can be adjusted between 3 lux approx. (dark)
and 1000 lux approx. (bright).
The detection range of the halogen floodlight projector can be changed by 40° horizontally and by 50°
vertically.
How to install the halogen floodlight projector with movement detector
The halogen floodlight projector with movement detector has to be fixed tightly to the wall. Vibrations will have
the same effects like thermal movement within the detection range.
About the location for installation
1. The space which you want to be detected has to be reached by the beams of the movement detector
(see pictures regarding the detection range as well).
2. The visibility of the space which you want to be detected should no be jammed with objects as the
infrared beams cannot go through solid objects.
3. The halogen floodlight projector has to be protected against rain, heavy wind and direct sunlight.
4. The detection range should be small. The bigger the range the higher the probability of incorrect switching.
You can limit the detection range by using non-transparent material (adhesive tape, for example).
The detection range should be at a 90° angle with the movement direction of objects
(see Pictures L and M). When an objects hits the detection range, a maximum of beams will bet touched.
Halogen floodlight projector with movement detector
+
DAYLIGHT
TIME
-
DAYLIGHT
-
+
TIME
GB