Liquid Vacuum Operation; Important; Blower Operation - Vacmaster PROFESSIONAL DVTB204 0201 Manual Del Operador

LIQUID VACUUM OPERATION

Note: The provided filter can be used for both wet and dry vacuum operation.
1. Verify that the cartridge filter is securely mounted ( Fig. 12). For installation instructions see
page 15.
2. Insert the hose into the vacuum port (Fig. 13).
3. Push required accessories onto the free end of the hose or the extension wand (Fig. 14).
4. Make sure the battery pack is correctly installed (Fig. 15). For installation instructions see page 10.
5. Turn the motor on by flipping the switch to the 'I' ON position (Fig. 16).
6. Once you have completed vacuuming, or when the tank is full, turn the motor off by flipping the
switch to the 'O' OFF position (Fig. 17).
7. Remove the battery and place it in the storage bay (Fig. 18).
8. Empty the collection tank into a suitable receptacle or drain (Fig. 19).

IMPORTANT!

nozzle completely in the liquid; leave a gap at the tip of the nozzle opening to allow air
inflow. The machine is fitted with a float valve that stops the suction action when the
collection tank reaches its maximum capacity. You will notice an increase in motor speed.
When this happens, turn off the machine, disconnect from power supply, and drain the
liquid into a suitable receptacle or drain. To continue vacuuming, refit the power head to the
collection tank. After wet vacuuming, turn the machine off and remove the battery. Empty
the collection tank, clean and dry the inside and outside before storage.
This wet/dry vacuum has blowing capabilities. To use the blower feature follow the
instructions listed.
WARNING:
WARNING:
WARNING:
INHALED.
20
24
When vacuuming large quantities of liquids, do not immerse the

BLOWER OPERATION

ALWAYS WEAR SAFETY GOGGLES WHILE USING BLOWER.
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
25
21
13
22 23